ATAVRDRAGON Datasheet, PDF (10/29 Pages) List of Unclassifed Manufacturers – Introducing AVR Dragon

Introduction
Status LEDs
Page 10 of 29
Two LEDs show the status of the AVR Dragon. Check the Troubleshooting Guide to check
for solutions if there are any errors.
LED Color Description
#
2
Green Indicates USB traffic
1
Red Idle, not connected to AVR
Studio
Dark Idle, connected to AVR
Studio
Green Data Transfere
Yellow Firmware Upgrade or
Initialization
In System Programming
In System Programming is well suited for programming devices soldered onto external
target boards. This section explains how to connect the AVR Dragon to ISP program an
external target. The ISP lines are equipped with level converters that automatically will
level shift the AVR Dragon to the target board voltage.
It is recommended that a 6-pin header connector with 2.54mm (100 MIL) spacing is placed
on the target board to allow easy access to the ISP programming interface. The following
file://C:\Documents and Settings\Administrator\...\~hh90C1.ht 2006-10-27