|
SGP02G72A1BQ1SA-DCRT Datasheet, PDF (1/17 Pages) List of Unclassifed Manufacturers – 2048MB DDR3 –Registered ECC RDIMM | |||
|
Preliminary Data Sheet
Rev.0.9 16.01.2014
2048MB DDR3 âRegistered ECC RDIMM
240 Pin registered DIMM
SGP02G72A1BQ1SA-xxRT
2GB in FBGA Technology
RoHS compliant
Options:
ï§ Data rate / Latency
DDR3 1600 MT/s CL11
Marking
-DC
ï§ Module density
2048MB with 9 dies and 1 rank
ï§ Standard Grade
(TA)
0°C to 70°C
(TC)
0°C to 85°C
*) The refresh rate has to be doubled when 85°C<TC<95°C
Environmental Requirements:
ï§ Operating temperature (ambient)
Standard Grade
0°C to 70°C
ï§ Operating Humidity
10% to 90% relative humidity, noncondensing
ï§ Operating Pressure
105 to 69 kPa (up to 10000 ft.)
ï§ Storage Temperature
-55°C to 100°C
ï§ Storage Humidity
5% to 95% relative humidity, noncondensing
ï§ Storage Pressure
1682 PSI (up to 5000 ft.) at 50°C
Features:
ï§ 240-pin 72-bit registered Dual-In-Line Double Data Rate
synchronous DRAM Module for Server applications
ï§ Module organization: single rank 256M x 72
ï§ VDD = 1.5V ±0.075V, VDDQ 1.5V ±0.075V
ï§ 1.5V I/O ( SSTL_15 compatible)
ï§ Fly-by-bus with termination for C/A & CLK bus
ï§ Supports ECC error detection and correction
ï§ Supports C/A bus parity
ï§ On-board I2C temperature sensor with integrated serial
presence-detect (SPD) EEPROM (JEDEC JESD21C)
ï§ Gold-contact pad
ï§ This module family is fully pin and functional compatible to
JEDEC PC3-10600 spec and MO-269 raw card A0.
(see www.jedec.org)
ï§ The pcb and all components are manufactured according
to the RoHS compliance specification [EU Directive
2002/95/EC Restriction of Hazardous Substances
(RoHS)]
DDR3 - SDRAM component Samsung K4B2G0846Q
ï§ 256Mx8 DDR3 SDRAM in PG-TFBGA-78 package
ï§ 8-bit prefetch architecture
ï§ Programmable CAS Latency, CAS Write Latency, Additive
Latency, Burst Length and Burst Type.
ï§ On-Die-Termination (ODT) and Dynamic ODT for improved
signal integrity.
ï§ Refresh. Self Refresh and Power Down Modes.
ï§ ZQ Calibration for output driver and ODT.
ï§ System Level Timing Calibration Support via Write Leveling
and Multi Purpose Register (MPR) Read Pattern.
Swissbit AG
Industriestrasse 4
CH â 9552 Bronschhofen
Fon: +41 (0) 71 913 03 03
Fax: +41 (0) 71 913 03 15
Figure: mechanical dimensions
if no tolerances specified ± 0.15mm)
www.swissbit.com
eMail: info@swissbit.com
Page 1
of 17
|
▷ |