PDUMH20AT Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – Single-Phase Auto Transfer Switch / Metered PDU, 1.9kW 20A 120V, 1U Horizontal Rackmount, 16 5-15/20R outlets

Single-Phase Auto Transfer Switch / Metered PDU,
1.9kW 20A 120V, 1U Horizontal Rackmount, 16
5-15/20R outlets, 2 L5-20P / 5-20P adapters
MODEL NUMBER: PDUMH20AT
Highlights
Single phase 20A 120V Auto
Transfer Switch / ATS PDU
Enables redundant-power option
for single-corded network devices
Separate primary & secondary
inputs connect to any two
compatible power sources
1U horizontal rackmount; 2
NEMA L5-20P / 5-20P inputs; 16
5-15/20R outlets
Two digit visual current meter;
Upgrade options available
Applications
Ideal means to provide
single-corded network gear a
redundant power option
Package Includes
Description
PDU with attached L5-20P
Tripp Lite Metered ATS / Auto Transfer Switch provides a redundant power option for single-corded network
primary input cord
devices. Dual input cords support separate connection to PRIMARY and SECONDARY power sources. The
Detachable C19 to NEMA
ATS will normally maintain continuous output to all outlets as derived from the primary input cable. If the primary
L5-20P secondary input cord
power source becomes unstable or fails altogether, the ATS will switch over to the secondary power source until
Set of two L5-20R to 5-20P plug
the primary input is restored and stable. Super-fast switchover between primary and secondary power sources
adapters
occurs within milliseconds. ATS functionality is supported by any two compatible AC power sources, regardless
1U mounting brackets
of phase angle, to support a variety of advanced redundant power networking applications. Enables fault tolerant
User manual with warranty
hot-swappable UPS protection when used with a single UPS and fully redundant UPS protection when each cord
information
is connected to a separate UPS system. In a two-UPS environment, the primary input cable must be supported
by a full time sine wave UPS with zero transfer time. Tripp Lite SmartOnline series is highly recommended for use as the primary UPS in a two-UPS
application. ATS configurations utilizing separate mains circuits, backup generators and even separate utility power grid feeds are fully supported. On-board
ATS processor constantly evaluates power quality on both input sources to prevent transfer to the secondary source when unavailable or of lower quality than
the primary source. Front input LED's display primary or secondary power availability.
Features
120V 20A Automatic Transfer Switch (ATS) / Metered PDU (Agency de-rated to 16A continuous)
Provides a redundant power option for critical networking equipment with a single input power cord
2 digit display reports output power consumption in amps
1U horizontal rackmount form factor; 14.5 in. / 36.8 cm depth
16 built-in NEMA 5-15/20R outlets (8 front / 8 rear)
Set of two 12 ft. / 3.6m NEMA L5-20P input cables with set of two 5-20P adapters support connection to separate PRIMARY and SECONDARY inputs
ATS circuits normally maintain output sourced from the primary input cable; As primary input power fails or becomes unstable, the ATS will switch to
maintain output sourced from the secondary input cable until power on the primary input is restored and stable
ATS configurations enable fault-tolerant, hot-swappable UPS protection when used with a single UPS and fully redundant UPS protection when each cord
1/3