IS42S32200L Datasheet, PDF (1/59 Pages) List of Unclassifed Manufacturers – 512K Bits x 32 Bits x 4 Banks (64-MBIT) SYNCHRONOUS DYNAMIC RAM

IS42S32200L
IS45S32200L
512K Bits x 32 Bits x 4 Banks (64-MBIT)
SYNCHRONOUS DYNAMIC RAM
OCTOBER 2012
FEATURES
• Clock frequency: 200, 166, 143, 133 MHz
• Fully synchronous; all signals referenced to a
positive clock edge
• Internal bank for hiding row access/precharge
• Single 3.3V power supply
• LVTTL interface
• Programmable burst length:
(1, 2, 4, 8, full page)
• Programmable burst sequence:
Sequential/Interleave
• Self refresh modes
• 4096 refresh cycles every 16ms (A2 grade) or
64ms (Commercia, Industrial, A1 grade)
• Random column address every clock cycle
• Programmable CAS latency (2, 3 clocks)
• Burst read/write and burst read/single write
operations capability
• Burst termination by burst stop and precharge
command
OVERVIEW
ISSI's 64Mb Synchronous DRAM IS42/45S32200L is
organized as 524,288bits x 32-bit x 4-bank for improved
performance.The synchronous DRAMs achieve high-speed
data transfer using pipeline architecture. All inputs and
outputs signals refer to the rising edge of the clock input.
KEY TIMING PARAMETERS
Parameter
Clk Cycle Time
CAS Latency = 3
CAS Latency = 2
Clk Frequency
CAS Latency = 3
CAS Latency = 2
Access Timefrom Clock
CAS Latency = 3
CAS Latency = 2
-5 -6 -7 Unit
5 6 7 ns
7.5 7.5 7.5 ns
200 166 143 Mhz
133 133 133 Mhz
4.8 5.4 5.4 ns
5.4 5.4 5.4 ns
OPTIONS
• Packages:
86-pin TSOP-II
90-ball TF-BGA
• Operating temperature range:
Commercial (0^oC to + 70^oC)
Industrial (-40^oC to + 85^oC)
Automotive Grade, A1 (-40^oC to + 85^oC)
Automotive Grade, A2: (-40^oC to +105^oC)
Copyright © 2011 Integrated Silicon Solution, Inc. All rights reserved. ISSI reserves the right to make changes to this specification and its products at any time without
notice. ISSI assumes no liability arising out of the application or use of any information, products or services described herein. Customers are advised to obtain the lat-
est version of this device specification before relying on any published information and before placing orders for products.
Integrated Silicon Solution, Inc. does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be ex-
pected to cause failure of the life support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications unless Integrated Silicon
Solution, Inc. receives written assurance to its satisfaction, that:
a.) the risk of injury or damage has been minimized;
b.) the user assume all such risks; and
c.) potential liability of Integrated Silicon Solution, Inc is adequately protected under the circumstances
Integrated Silicon Solution, Inc. — www.issi.com
1
Rev.A
10/17/2012