ENA-0806 Datasheet, PDF (1/4 Pages) List of Unclassifed Manufacturers – specification describes the requirements of 60 watts switching power supply

_E_n_h_a_n_ce__E_l_ec_t_r_o_n_ic_s_C__o_.,_L_T_D_________________________________________P__ro_d_u_c_t_S_p_e_c_i_fi_c_at_io__n
MODEL NO. ENA-0806
This specification describes the requirements of 60 watts
switching power supply .
F 1.0 INPUT REQUIREMENTS
1.1 AC input requirements
The input voltage, current, and frequency requirements for continuous
operation are stated below.
Table 1 AC Input Line Requirements
Parameter
Min
Nom.
Max
Unit
Input voltage
90
100-240
264 VACrms
Vin Frequency
47
50/60
63
Hz
Input current
1.5
Arms
Full voltage range.
1.2 Inrush current
60Amps Maximum(for 230Vac).
30Amps Maximum(for 115Vac)(at cold start).
F 2.0 OUTPUT REQUIREMENTS
2.1 Voltage & output current load range & ripple
Parameter
+12
Parameter
+12
Range
Min
+/-5%
11.4
0
Ripple Max.
100
Nom.
Max
12
12.6
5
Ripple&Noise Max
120
Unit
Volts
Amps
Unit
mVp-p
2.1-1.At +12V surge, regulation can go to +/-10%.
2.1-2.The maximum continuous average dc output power shall not exceeed 60 watts.
2.2 Output Ripple Definition.
The ripple voltage of the output shall be measured at the pins of the output connector
AUDIT:__________________CHECK:____________________DESIGN:____________________
ENA-0613S SPEC REV.A0
1 OF 4
2003/03/21