5811 Datasheet, PDF (5/11 Pages) Allegro MicroSystems – BiMOS II 12-BIT SERIAL-INPUT, LATCHED SOURCE DRIVERS

JP10 – Flat Cable Display Connector
This FPC connector is compatible with the Hitachi SP14Q002 display.
1 LCDD4
2 LCDD5
3 LCDD6
4 LCDD7
5 LCDPWROFF
6 LCDFRAME
7
8 LCDLINE
9 LCDCLK
10 VCC
11 GND
12 VEE
13 GND
14 GND
Display data
Display data
Display data
Display data
H=display off, L=display on
Frame clock
Line clock
Dot clock
+5V supply
-21V ±1V (for Hitachi)
Edge
of
board
Pin 1
contacts at
top of
connector
JP10
JP9 – Generic QVGA Display Connector
This is compatible witrh the connector adapter supplied with the Hitachi SP14Q002 display starter kit. It
provides all the connections available from the QVGA display driver module, including touch screen
connections, and is designed to be easily adapted to the requirements of most other QVGA display hardware
via a suitable intermediate connector adapter. For more information on the signal usage see the QVGA
(5809) data sheet.
0.1" pin header 2 x 14 pins
1 D0
LCDD4
2 D1
LCDD5
3 D2
LCDD6
4 D3
LCDD7
5 D4
6 D5
7 D6
8 D7
9 GND
10 LCDPWROFF H=display off, L=display on
11 LCDCLK
Dot clock
12 LCDFRAME Frame clock
13 GPIO0
General purpose I/O
14 LCDLINE
Line clock
15 LCDPWRON L=display off, H=display on
16 GND
17 VCC
18 VEE
19 VADJ
20 GND
Negative supply: set with R8 and LK1
Contrast voltage: set with R7
21 VBATT1
22 VBATT2
23 IN1
Analogue inputs (see QVGA documenation)
24 IN2
25 X+
26 X-
Touch Screen Inputs (see QVGA
27 Y+
documentation)
28 Y-
Pin 1
Edge
of
board
JP9
Pin 2
Doc 44306 V20041130
VM-1 Application Board 3 (Issue A)
Page 5 of 11