A1042 Datasheet, PDF (12/24 Pages) List of Unclassifed Manufacturers – Desoldering Tool

Troubleshooting Guide
WARNING : If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarity qualified person in order
to avoid personal injury or damage to the
unit.
 Power lamp does not light up.
• Is the power cord plugged in correctly.
Securely insert the power cord into the power supply.
• Is the fuse blown?
Determine why the fuse blew and eliminate the cause,
then replace the fuse.
Example Is the inside of the gun short-circuited?
 Solder is not being absorbed.
• Is the spring filter full of solder?
Replace it with a new one. (refer to p.13)
• Is the ceramic filter hardened?
Replace it with a new one .
• Is there a vacuum leak?
Check the connections and replace any worn parts.
(refer to p.10)
• Is the compressor providing the proper air pressure?
Check the air pressure and the inside diameter and
length of the tube. (refer to p.6)
 The nozzle does not heat up.
• Is the desoldering gun cord assembly properly con-
nected?
Reconnect it. (refer to p.6)
• Is the heating element damaged?
Replace it. (refer to p.17)
NOTE : When repairs are needed, please send both the
desoldering gun and the station to your sales
agent.
11