English
Language : 

PAK-I Datasheet, PDF (6/28 Pages) List of Unclassifed Manufacturers – 310 Ivy Glen Court
Pin Connections
Pin Name
Type
Description
18 Busy/Mode Input/Output This pin has two functions. At start up, if the
pin is pulled up by a resistor, the PAK1 uses
this pin as a busy indicator. The pin will read 0
when the PAK1 is not busy. However, if at
startup the pin is pulled to ground, the PAK1
will indicate its busy status on the Enable/
Busy pin.
17 Enable/
Input or
If Busy/Mode is pulled high at start up, the
Busy
Open
Enable/Busy pin is only an input. Bring it low
Collector
to disable the PAK1, or high to enable it.
Output
However, if Busy/Mode is pulled low at start
up, this pin serves as an open-collector I/O
pin. If the host pulls the pin low, it disables the
PAK1. If the PAK1 is busy, it pulls the pin
low.
3 CLK
Input
The host pulses the CLK pin to shift data in or
out of the PAK1.
1 SIN
Input
The PAK1 reads data from this pin. You may
short SIN and SOUT and use the same pin for
input and output if the host is capable of
treating a single pin as an I/O pin.
2 SOUT
Open
The PAK1 writes data to the host on this pin.
Collector
Since the pin is open collector, you'll need a
Output
resistor to 5V on this pin. You may short SIN
and SOUT together to use one pin for I/O
4 RESET
Input
Hardware resets the PAK1 when low.
5 VSS
Power
Ground
14 VDD
Power
+5V
15 RES1
Clock
Connects to resonator
16 RES2
Clock
Connects to resonator
6- B0-B7
I/O
13
General purpose I/O