G3PA Datasheet, PDF (6/16 Pages) List of Unclassifed Manufacturers – Power Solid-state Relay

I Replacement Procedure
G32A-A10(L)-VD/G32A-A20(L)-VD/G32-A420-VD(-2)
Use the special tool (provided) to extract the cartridge for replacement with a new one.
Extraction
Follow the procedures below to dismount the Power Device Car-
tridge from the G3PA.
1. Switch off the power.
2. Remove the terminal cover.
3. Hook the indented part of the cartridge with the tool and pull up
on the cartridge to remove it.
Remover
Hook here with
Remover.
Apply silicone grease here.
2. Make sure that there is no dust or pieces of wire on the heat radi-
ator of the G32A-A or the G3PA.
3. Insert the cartridge into the opening of the G3PA so that the let-
ters on the cartridge and those on the G3PA are in the same
direction and side A and side B are even.
Side A
Side B
Mounting
Follow the procedures below to mount the Power Device Cartridge
on the G3PA.
1. Apply silicone grease (provided with the G32A-A) to the entire
surface of the heat radiator.
4. Attach the terminal cover.
5. Switch on the power and check the G3PA to be sure it works
properly.
G32A-A40(L)-VD/G32A-A60(L)-VD/G32A-A430-VD(-2)/G32A-A450-VD-2
The G32A Power Device Cartridge is mounted and secured with screws to the G3PA Unit.
Extraction
Follow the procedures below to dismount the G32A-A Power Device
Cartridge from the G3PA.
1. Switch off the power.
2. Remove the terminal cover.
3. Loosen the two centered screws on the sides to dismount the car-
tridge. The screws are connected to terminals 1 and 2.
Mounting
1. Apply silicone grease to the entire surface of the heat radiator.
Loosen
Loosen
4. Loosen the screws on both the corners.
Apply silicone grease here.
2. Make sure that there is no dust or pieces of wire on the radiator of
the G32A-A or the G3PA.
Loosen
Loosen
5. Hold the indented part of both the corners to dismount the car-
tridge.
J-26
Power Solid-state Relay G3PA-(VD)