5811 Datasheet, PDF (4/11 Pages) Allegro MicroSystems – BiMOS II 12-BIT SERIAL-INPUT, LATCHED SOURCE DRIVERS

Configuration
MAKE eth Protocol("eth", 1, $d0, my_ip_address)
The second and third parameter specify I²C bus 1 and the correct addressing information to select the
ethernet position on the 5811 application board.
See the Venom Networking Guide for more information, including the use of the my_ip_address
parameter.
QVGA Module
N.B. Before powering up with a display connected, first adjust the supply voltage (see page 6)
If a QVGA module 5810 is required, plug it into the QVGA module sockets. Securing via mounting holes is
optional as the board is fairly well held in by the connectors and is not subject to cable pulling forces.
Connect a Hitachi display type SP14Q002 or compatible to JP10. The application board's corner mounting
holes enable it to be mounted directly on pillars on the display module.
Other types of display can be connected via a suitable adapter to JP9, which will also work with the adapter
supplied with the SP14Q002 starter kit.
The Hitachi touch screen can be connected to JP14.
Other electrically compatible touch screens can be adapted to connect to JP13.
Consult the pinout diagrams below for interconnection details.
Doc 44306 V20041130
VM-1 Application Board 3 (Issue A)
Page 4 of 11