5811 Datasheet, PDF (1/11 Pages) Allegro MicroSystems – BiMOS II 12-BIT SERIAL-INPUT, LATCHED SOURCE DRIVERS

VM-1 Application Board 3
5811
VM-1 Application Board 3 (Issue A) Data Sheet
Introduction
The 5811 is an application board for use with the VM-1 Control Module. It provides connections for modules
such as the 5809 QVGA display interface and 5810 ethernet controller. To support the QVGA the board has
connectors for both display and touch screen. The board also has an RS232 serial port, an optional second
serial port, an I²C connector on Bus 1, and an on-board EEPROM for non-volatile data storage. Additionally
all the digital and analogue channels on the VM-1 connector are available.
This document applies only to Issue A of the board. Issue B has extensive extra capabilities and a slightly
different layout and is better suited to QVGA use.
Serial
Port 1
Serial
Port 2
V_EE adjust
Power
Contrast
control
QVGA
display
connectors
Location of
Ethernet
module
Location
of QVGA
module
Location
of VM-1
controller
101 113
mm mm
4x
3.5mm
Touch screen
I²C
connectors
152mm
164mm
Unpacking
You should have:
• 5811 Application Board. This document applies to Issue A of the board only.
• Power Connector
• These Instructions
WARNING: Users of Micro-Robotics Control Equipment should be aware of the possibility of a system failure, and must consider the
implications of such failure. Micro-Robotics Ltd. can accept no responsibility for loss, injury, or damage resulting from the failure of our
equipment. Use of our products in applications where their failure to perform as specified could result in injury or death is expressly
forbidden.
© 2004 Micro-Robotics Ltd
The Old Maltings
135 Ditton Walk
Cambridge
CB5 8QB
tel: [phone]
fax: [phone]
[e-mail]
www.microrobotics.co.uk
Doc 44306 V20041130
VM-1 Application Board 3 (Issue A)
Page 1 of 11