|
iC-m59 Datasheet, PDF (32/36 Pages) List of Unclassifed Manufacturers – VHF MARINE TRANSCEIVER | |||
|
◁ |
7 TROUBLESHOOTING
PROBLEM
No power comes on.
POSSIBLE CAUSE
⢠Power cord not connected properly.
⢠Blown fuse.
SOLUTION
REF.
⢠Check the power cord connection.
p. 23
⢠Check the polarity of the power connection, then, p. 26
replace the fuse.
No sound comes from the
speaker.
⢠[SQUELCH] is rotated too far clockwise.
⢠Rotate [SQUELCH] counterclockwise to a suit- p. 8
able position.
No beeps sound even when a ⢠Beep function is turned OFF.
switch is pushed.
⢠Set beeps to ON in SET mode.
p. 20
Sensitivity is low and only
strong signals are audible.
⢠[SQUELCH] is rotated too far clockwise.
⢠Antenna feedline or the antenna connector sol-
der has poor contact or is short circuited.
⢠Rotate [SQUELCH] counterclockwise to a suit-
able position.
⢠Check, and if necessary, replace the feedline or
solder the antenna connector again.
p. 8
p. 23
Transmitting is impossible or
high power cannot be se-
lected.
⢠Transmission is restricted on some channels.
⢠Change channels.
p. 29
Desired channel cannot be
selected.
⢠Different channel group is selected.
⢠Push and hold [CH/WX ⢠U/I/C] to select the ap- p. 7
propriate channel group (U.S.A., INT or CAN).
No display backlighting.
⢠Backlight function is turned OFF.
⢠While pushing [HI/LO ⢠DIM], rotate the channel p. 11
selector to select the desired brightness.
Scan does not start.
⢠No âTAGâ channels are programmed.
⢠Set channels to be scanned as âTAGâ channels. p. 10
Receive signal cannot be un- ⢠Voice scrambler has been turned OFF.
⢠Install the optional UT-79, then activate the func- p. 8
derstood.
⢠Voice scrambler code has not been set correctly. tion.
p. 20
⢠Reset the scramble code.
28
|
▷ |