|
iC-m59 Datasheet, PDF (14/36 Pages) List of Unclassifed Manufacturers – VHF MARINE TRANSCEIVER | |||
|
◁ |
3 BASIC OPERATION
I Scan function
The transceiver has a high speed scan function for standing
by on utility signals. The scan speed is 8 channels/sec. (ex-
cept when the weather alert function is in use).
Two scan types are available: normal scan (scans all tag
channels in sequence) and priority scan (checks channel 16
while scanning). These scans can be selected in set mode
(p. 19).
D Scan operation
â Select the desired channel group (USA, CAN, INT) or WX
channels with [CH/WXâ¢U/I/C].
⢠When the weather alert function is in use, select the desired WX
channel in the display, then perform the above operation.
â Push [SCAN] to start scanning.
⢠âSCANâ appears and ï¬ashes in the function display.
⢠â16â appears during priority scan.
â To stop the scan, push [SCAN] again.
⢠âSCANâ disappears.
D Setting tag channels
You can specify channels as tag channels for efï¬cient scan-
ning. Tag channels can be set for each channel group (USA,
CAN, INT) independently.
⥠Select the desired channel, then push and hold
[SCANâ¢TAG] for 1 sec. to toggle the tag setting.
â Scan resume timer:
When a signal is detected, scan pauses until the signal dis-
appears or resumes after pausing 5 sec., according to the set
mode setting. (p. 19)
TAG
Appears when the channel is
USA
specified as a tag channel.
â Clearing all tag channels:
While pushing [HI/LO], push and hold [SCANâ¢TAG] for 3 sec.
until the long beep becomes 2 short beeps.
⢠All tag channels in the selected channel group are released.
â Conï¬rming tag channels:
While operating scan, rotate [DIAL].
⢠Only tag channels are selected.
⢠Stop rotating [DIAL] to resume scan.
â Weather alert function:
When the function is turned ON (p. 19), the selected weather
channel is checked during scan. Refer to p. 7 for a descrip-
tion of weather alert.
10
|
▷ |