8407201RA Datasheet, PDF (3/17 Pages) List of Unclassifed Manufacturers – MICROCIRCUIT, DIGITAL, HIGH-SPEED CMOS, OCTAL TRANSPARENT D-TYPE LATCHES WITH THREE STATE OUTPUTS MONOLITIC SILICON

1.2.5 Lead finish. The lead finish is as specified in MIL-PRF-38535 for device classes Q and V or MIL-PRF-38535, appendix A
for device class M.
1.3 Absolute maximum ratings. 1/ 2/ 3/
Supply voltage range (VCC).................................................................................. -0.5 V dc to +7.0 V dc
DC input voltage range (VIN)................................................................................ -0.5 V dc to VCC +0.5 V dc
DC output voltage range (VOUT)........................................................................... -0.5 V dc to VCC +0.5 V dc
Input clamp current (IIK) (VIN < 0.0 or VIN > VCC) .................................................. ±20 mA
Output clamp current (IOK) (VOUT < 0.0 or VOUT > VCC)......................................... ±20 mA
Continuous output current (IOUT) (VOUT = 0.0 to VCC) ........................................... ±35 mA
Continuous current through VCC or GND ............................................................. ±70 mA
Storage temperature range (TSTG)....................................................................... -65°C to +150°C
Maximum power dissipation (PD):........................................................................ 500 mW 4/
Lead temperature (soldering, 10 seconds).......................................................... +260°C
Thermal resistance, junction-to-case (θJC) .......................................................... See MIL-STD-1835
Junction temperature (TJ) .................................................................................... +175°C 5/
1.4 Recommended operating conditions. 2/ 3/
Supply voltage range (VCC).................................................................................. +2.0 V dc to +6.0 V dc
Case operating temperature range (TC) ............................................................. -55°C to +125°C
Input rise or fall time tr, tf):
VCC = 2.0 V ...................................................................................................... 0 to 1,000 ns
VCC = 4.5 V ...................................................................................................... 0 to 500 ns
VCC = 6.0 V ...................................................................................................... 0 to 400 ns
Minimum setup time, data before LE↓ (ts):
TC = +25°C:
VCC = 2.0 V ........................................................................................................ 100 ns
VCC = 4.5 V ........................................................................................................ 20 ns
VCC = 6.0 V ........................................................................................................ 17 ns
TC = -55°C to +125°C:
VCC = 2.0 V ........................................................................................................ 150 ns
VCC = 4.5 V ........................................................................................................ 30 ns
VCC = 6.0 V ........................................................................................................ 26 ns
1/ Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
2/ Unless otherwise noted, all voltages are referenced to GND.
3/ The limits for the parameters specified herein shall apply over the full specified VCC range and case temperature range of
-55°C to +125°C.
4/ For TC = +100°C to +125°C, derate linearly at 12 mW/°C.
5/ Maximum junction temperature shall not be exceeded except for allowable short duration burn-in screening conditions in
accordance with method 5004 of MIL-STD-883.
STANDARD
MICROCIRCUIT DRAWING
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43216-5000
DSCC FORM 2234
APR 97
SIZE
A
REVISION LEVEL
F
84072
SHEET
3