MB-TFT-35-S4-S Datasheet, PDF (21/23 Pages) List of Unclassifed Manufacturers – Suitable for cell phone application the Main LCD adopts one backlight with High brightness 6-lamps white LED

MB-TFT-35-S4-S
4) If the LCD element breaks and any LC stuff leak, do not suck or lick it. Also
if LC stuff is stuck on your skin or clothing, wash thoroughly with soap and
water immediately.
10.2 Installing precautions
1) The PCB has many ICs that may be damaged easily by static electricity.
To prevent breaking by static electricity from the human body and clothing,
earth the human body properly using the high resistance and discharge static
electricity during the operation. In this case, however, the resistance value
should be approx. 1MΩ and the resistance should be placed near the human
body rather than the ground surface. When the indoor space is dry, static
electricity may occur easily so be careful. We recommend the indoor space
should be kept with humidity of 60% or more. When a soldering iron or other
similar tool is used for assembly, be sure to earth it.
2) When installing the module and ICs, do not bend or twist them. Failure to
do so may crack LC element and cause circuit failure.
3) To protect LC element, especially polarizing plate, use a transparent
protective plate (e.g., acrylic plate, glass etc) for the product case.
4) Do not use an adhesive like a both-side adhesive tape to make LCD
surface (polarizing plate) and product case stick together. Failure to do so
may cause the polarizing plate to peel off.
10.3 Storage precautions
1) Avoid a high temperature and humidity area. Keep the temperature
between 0°C and 35°C and also the humidity under 60%.
2) Choose the dark spaces where the product is not exposed to direct
sunlight or fluorescent light.
3) Store the products as they are put in the boxes provided from us or in the
same conditions as we recommend.
10.4 Operating precautions
1) Do not boost the applied drive voltage abnormally. Failure to do so may
break ICs. When applying power voltage, check the electrical features
beforehand and be careful. Always turn off the power to the LC module
controller before removing or inserting the LC module input connector. If the
input connector is removed or inserted while the power is turned on, the LC
module internal circuit may break.
2) The display response may be late if the operating temperature is under the
normal standard, and the display may be out of order if it is above the normal
Company Confidential Ver
All Rights Reserved©WINCOM
21