SPT9404 Datasheet, PDF (2/4 Pages) List of Unclassifed Manufacturers – SINGLE VIDEO DRIVER

ABSOLUTE MAXIMUM RATINGS (Beyond which damage may occur)⁽¹⁾ 25 °C
Supply Voltages
V_CC ....................................................................... +6.0 V
Maximum Power Dissipation
P_D .................................................................................... 150 mW
Thermal Impedance (T_A=+25 °C and above)
Θ_CA ............................................................................ 1.2 mW/°C
Temperature
Operating Temperature ................................. 0 to +70 °C
Storage Temperature ................................ -55 to +150 °C
Note: 1. Operation at any Absolute Maximum Rating is not implied. See Electrical Specifications for proper nominal
applied conditions in typical applications.
ELECTRICAL SPECIFICATIONS
T_A = +25 °C, V_CC = +5.0 V, V_IN = 1.0 V_P-P video signal, voltage gain of +2, R_L = 150 Ω, unless otherwise specified.
PARAMETERS
Power Supply
Supply Current (I_CC)
V_CC Voltage
Power Dissipation
Standby Current
Standby Power Dissipation
Digital Input
Digital Input (Low)
Digital Input (High)
Dynamic Performance
Voltage Gain
Total Harmonic Distortion
Open Loop Gain
Bandwidth
Slew Rate
Frequency Response
Voltage Output Maximum (V_OM)
TEST
CONDITIONS
No Input
Pin 1 Grounded
Pin 1 Grounded
Standby Pin 1
Standby Pin 1
f_IN = 1.0 MHz
f_IN = 1.0 kHz
f_IN = 1 to 5 MHz
TEST
LEVEL
I
IV
I
I
I
I
I
I
I
V
V
V
V
I
SPT9404
MIN
TYP
6.3
4.5
5.0
31.5
24
96
0.0
0.1
1.8
2.0
5.7
6.0
0.2
40
20
70
0.0
1.0
1.2
MAX UNITS
8.5 mA
5.5 V
42.5 mW
50 µA
250 µW
0.3 V
V_CC V
6.3 dB
1.0 %
dB
MHz
V/µs
dB
V_RMS
TEST LEVEL CODES
All electrical characteristics are subject to the following
conditions:
All parameters having min/max specifications are guar-
anteed. The Test Level column indicates the specific
device testing actually performed during production and
Quality Assurance inspection. Any blank section in the
data column indicates that the specification is not tested
at the specified condition.
TEST LEVEL
I
II
III
IV
V
VI
TEST PROCEDURE
100% production tested at the specified temperature.
100% production tested at T_A = +25 °C, and sample tested
at the specified temperatures.
QA sample tested only at the specified temperatures.
Parameter is guaranteed (but not tested) by design and
characterization data.
Parameter is a typical value for information purposes only.
100% production tested at T_A = +25 °C. Parameter is
guaranteed over specified temperature range.
SPT
2
SPT9404
8/25/98