HCPLM700 Datasheet, PDF (2/8 Pages) List of Unclassifed Manufacturers – Small Outline, 5 Lead, Low Input Current, High Gain Optocouplers

2
The HCPL-M701 is for use in
CMOS, LSTTL or other low
power applications. A 400%
minimum current transfer ratio
is guaranteed over a 0-70°C
operating range for only 0.5 mA
of LED current.
The HCPL-M700 is designed for
use mainly in TTL applications.
Current Transfer Ratio is 300%
minimum over 0-70°C for an
LED current of 1.6 mA [1 TTL
Unit Load (U.L.)]. A 300% CTR
enables operation with 1 U.L.
out with a 2.2 kΩ pull-up
resistor.
Selection for lower input
currents down to 250 µA is
available upon request.
Outline Drawing (JEDEC MO-155)
Applications
• Ground Isolate Most Logic
Families - TTL/TTL, CMOS/
TTL, CMOS/CMOS, LSTTL/
TTL, CMOS/LSTTL
• Low Input Current Line
Receiver
• EIA RS232C Line Receiver
• Telephone Ring Detector
• ac Line Voltage Status
Indicator - Low Input
Power Dissipation
• Low Power Systems -
Ground Isolation
4.4 ± 0.1
(0.173 ± 0.004)
MXXX
XXX
ANODE 1
7.0 ± 0.2
(0.276 ± 0.008)
CATHODE 3
6 V_CC
5 V_OUT
4 GND
0.4 ± 0.05
(0.016 ± 0.002)
3.6 ± 0.1*
(0.142 ± 0.004)
2.5 ± 0.1
(0.098 ± 0.004)
0.102 ± 0.102
(0.004 ± 0.004)
1.27 _BSG
(0.050)
(00.0.7218)MIN.
DIMENSIONS IN MILLIMETERS (INCHES)
* MAXIMUM MOLD FLASH ON EACH SIDE IS 0.15 mm (0.006)
0.15 ± 0.025
(0.006 ± 0.001)
7° MAX.
MAX. LEAD COPLANARITY
= 0.102 (0.004)
"HP" IS MARKED ON THE
UNDERSIDE OF THE PACKAGE
Pin Location (for reference only)
4.4
(0.17)
0.3
(0.01)
2.5
(0.10)
1.3
(0.05)
0.9
(0.04)
7.2
(0.28)
0.5
(0.02)
Schematic
+ ^IF
ANODE
1
V_F
–
CATHODE
3
6
V_CC
I_CC
I_{O 5}
V_O
4
GND