GS7000 Datasheet, PDF (2/14 Pages) List of Unclassifed Manufacturers – Serial Digital Video Transceiver

ABSOLUTE MAXIMUM RATINGS
PARAMETER
Supply Voltage
Input Voltage Range (any input)
DC Input Current (any one input)
Power Dissipation (V_CC = 5.25 V)
Maximum Die Temperature
Operating Temperature Range
Storage Temperature Range
Lead Temperature (soldering 10s)
VALUE
5.5V
V_EE < V_IN < V_CC
10mA
830mW
125°C
0°C ≤ T_A ≤ 85°C
-65°C ≤ T_S ≤ 150°C
260°C
AC ELECTRICAL CHARACTERISTICS (Receiver Mode)
V_CC = 5V, V_EE = 0V, T_A = 0°C to 85°C, unless otherwise specified.
Serial Data Rate = 270Mb/s, Parallel Data Rate = 27Mb/s, f_PCLK = 27MHz
PARAMETER
CONDITIONS
SYMBOL MIN TYP MAX
Parallel Data Output - Rise/Fall Time
C_L = 20pF
t_{R/F_PDO}
1.0
-
6.0
PCLK rising edge to D_OUT(n) center
t_D
-
-
±5
PCLK rise/fall time
C_L = 20pF
t_{R/F_PCLKo}
0.5
-
3.0
Input Return Loss
75Ω match
5MHz -> 270MHz
LOSS_IN
-
17
-
Asynchronous Lock Time
t_{LOCK_ASYNC}
-
-
250
Synchronous Lock Time
t_{LOCK_SYNC}
-
-
10
Input Jitter Tolerance
pathological Input
t_{J_SI}
-
0.4
-
Output PCLK Jitter
pathological Input
t_{J_PCLKo}
-
1000
-
Max Error Free Cable Length
pathological Input
75 100
-
NOTES
1. Rise/Fall time is defined as the time for the signal to rise from 20% to 80% of the specified p-p value,
or to fall from 80% to 20% of the specified value.
2. Refer also to Figure 21.
3. This is the time difference between the rising edge of PCLK_OUT and the center of the bit period.
4. This is the time delay between a valid serial TRS signal on the input, to the moment valid data
appears on the parallel outputs.
5. This is the time for the PLL to re-lock when video streams are switched during the vertical blanking
interval in accordance with SMPTE RP168-1993. The two streams may be 180° out of phase with
respect to one another, but pixel aligned.
6. This pathological pattern is defined in SMPTE RP178-1996, paragraphs 4.1 and 4.3.
7. "Error free" is defined as no single bit errors over a period of 10 minutes, using Belden 8281 Cable
and 75Ω connections. The MIN value is fully tested and the TYP value is based on using the
EB7000 Evaluation Board.
UNITS
NOTES
TEST
LEVEL
ns
1
1
ns
2, 3
1
ns
1
1
dB
6
ms
4
1
µs
5
1
U.I.
6
4
ps p-p
6
1
m
6, 7
1, 4
TEST LEVELS
1. 100% tested at 25 °C
2. Guaranteed by design
3. Inferred or correlated
value
4. Evaluated using test
setup Figure 1a.
5. Evaluated using test
setup Figure 1b.
6. Evaluated using test
setup Figure 1c.
2
522 - 06 - 02