B-166 Datasheet, PDF (2/2 Pages) List of Unclassifed Manufacturers – MIRROR WITH STAINLESS STEEL CHANNEL FRAME AND SHELF

INSTALLATION:
Mount wall hanger on wall with screws (furnished by manufacturer) at points indicated by an S. For plaster or dr y wall
construction, provide backing to comply with local building codes, then secure wall hanger with screws furnished. When
providing a concealed backing, allow backing to cover minimum range of mounting hole locations shown on drawing. For
other wall surfaces, provide fiber plugs or expansion shields for use with screws furnished, or provide 1/8" (3mm) toggle
bolts or expansion bolts. Hang mirror on wall hanger with all four backplate louvers engaged behind horizontal wall hanger
members. To do this, mirror must be centered in front of the wall hanger horizontally, pressed flat against the wall approxi-
mately 1" (25mm) above final position and then lowered into final position.
Snap Locking Design — Locking devices automatically secure mirror to concealed wall hanger when it is lowered into
final position. Locking devices may be unlocked by inserting two flat blade screwdrivers behind each side of mirror near the
bottom or under the bottom of the mirror and pulling mirror bottom for ward and then up (see figure 3).
Screw locking Design — Lock mirror to wall hanger by tightening Phillips-head locking screws that are concealed in the
bottom of frame by points indicated by a T. Mirror may be unlocked from wall hanger by loosening locking screws and
lifting mirror off of concealed wall hanger (see figure 4).
SNAP LOCKING DESIGN
(Front View)
Approx. 1"
(25mm)
CL
Initial
Position
Final
Position
S
SCREW LOCKING DESIGN
(Front View)
Approx. 1"
(25mm)
CL
S
Initial
Position
Final
Position
S
S
Figure: 3
T
T
Figure: 4
SPECIFICATION:
Mirror shall have a one-piece type 430 stainless steel channel frame, 1/2" x 1/2" x 3/8" (13 x 13 x 9.5mm), with 90° mitered
corners; all exposed surfaces shall have bright polished finish. Shelf shall be type 304, 22-gauge (0.8mm) stainless steel with
satin finish and shall have 3/8" (10mm) return edges on front and sides with front return edge hemmed. Shelf shall be
welded to mirror frame and reinforced by concealed stainless steel brackets. No rivet-heads, screws, or fasteners of any kind
shall be exposed on frame or shelf. Select float glass mirror shall be guaranteed for 10 years against silver spoilage. Corners
shall be protected by friction-absorbing filler strips and the back shall be protected by full-size, shock-absorbing, water-
resistant, nonabrasive, 3/16" (5mm) thick polyethylene padding. Galvanized steel back shall have integral horizontal hanging
brackets located at top and bottom for mounting on concealed rectangular wall hanger and to prevent the mirror from pulling
away from the wall. Locking devices secure mirror to concealed wall hanger. Mirror shall be removable from wall.
Framed Mirror With Shelf shall be Model B-166 _______________ (insert width and height) of Bobrick
Washroom Equipment, Inc., Clifton Park, New York; Jackson, Tennessee; Los Angeles, California; Bobrick
Washroom Equipment Company, Scarborough, Ontario; Bobrick Washroom Equipment Pty. Ltd., Australia; and
Bobrick Washroom Equipment Limited, United Kingdom.
The illustrations and descriptions herein are applicable to production as of the date of this Technical Data Sheet.
The manufacturer reserves the right to, and does from time to time, make changes and improvements in designs and dimensions.
B-166 Rev. 5/06 R/B
Printed in U.S.A.
© 2006 by Bobrick Washroom Equipment, Inc.