D4DL Datasheet, PDF (13/16 Pages) List of Unclassifed Manufacturers – Compact Guard-locking Interlock Safety Door Switch

D4DL
Switch Mounting Holes
Three, M4
D4DL
Wire the crimp terminal as shown in the following diagram so that it
will not come in contact with the case or cover.
Correct
Terminal screw
Incorrect
Operation Key Mounting Holes
• Horizontal/Vertical Mounting
D4DSK1/D4DS-K2
Two, M4
• Horizontal-adjustable Vertical Mounting
D4DS-K3
Two, M4
• Horizontal/Vertical-adjustable Vertical Mounting
D4DS-K5
41^±0.1
43^±0.1
Two, M4
Head Direction
By removing the four screws of the head, the mounting direction of
the head can be changed. The head can be mounted in four direc-
tions.
Wiring
Do not connect lead wires directly to the terminals. Be sure to con-
nect the lead wires through insulation tubes and crimp terminals.
The lead wires must be an AWB20 to AWG18 type (i.e., 0.5 to 10
mm² thick).
Crimp terminal
Conduit Opening
Connect a recommended connector (see following table) to the
opening of the conduit and tighten the connector to the proper
torque. The casing may be damaged if an excessive tightening
torque is applied.
Be sure that the diameter of the cable connected to the connector is
correct.
Attach and tighten a conduit cap to the unused conduit opening
when wiring the D4DL. The conduit cap is provided with the D4DL.
Recommended Connectors
Size
G¹/₂
Pg13.5
Manufacturer
Model
OMRON
LAPP
Ohm Denki
LAPP
HEYCO
SC-6
ST-PF1/2
5380-1002
OA-W1609
ST13.5
5301-5030
3216
Proper cable
diameter
7.5 to 9.0 mm
6.0 to 12.0 mm
7.0 to 9.0 mm
5.0 to 12.0 mm
4.3 to 11.9 mm
Note: LAPP is a German manufacturer.
Ohm Denki is a Japanese manufacturer.
HEYCO is an American manufacturer.
Maintenance and Repairs
Please note in the machine manufacturer’s instruction manual that
the user must not repair or maintain the switch and must contact the
machine manufacturer for any repairs or maintenance.
Others
The solenoid radiates heat when power is supplied to the solenoid.
Do not touch the solenoid while the power is supplied.
Use the D4BL under conditions requiring greater rigidity, sealing
performance, and oil resistance.
dz dia.:
D dia.:
B:
L:
F:
I:
3.7
4.5
7.0
20.2
7.7
9.0 (mm)
D dia.
dz dia.
13