CLR79 Datasheet, PDF (11/12 Pages) List of Unclassifed Manufacturers – Commercial Types TAT for CLR79 and TAX for CLR81

Wet
Tantalum
-
CLR 79 (MIL-C-39006/22)
CLR 81 (MIL-C-39006/25)
Dielectric withstanding voltage
• MIL-STD-202 – Method 301, 2000 VDC minimum
Insulation Resistance (IR): MIL-STD-202 – Method 302, condition B
• 100 Megohms minimum
Low temperature storage: MIL-STD-810 – Method 502
• DCL and DF: Initial requirements
• ∆Cap within ±5% of initial measurement
Low and high temperature stability: –55°C to +125°C.
Measure capacitors for thermal stability by testing at these temperatures in this order: +25°C, –55°C, +25°C, +85°C,
+125°C, and +25°C. Measure Capacitance and DF at the temperatures listed below with the exception of the DCL, which
is not measured at –55°C.
• Step 1 (+25°C)
DCL and DF: See standard ratings table
∆Cap: Within tolerance of standard ratings table
• Step 2 (–55°C)
Impedance and ∆Cap: See standard ratings table
• Step 3 (+25°C)
DCL and DF: See standard ratings table
∆Cap: Within ±5% of step one value
• Step 4 (+85°C)
∆Cap, DCL, and DF: See standard ratings table
• Step 5 (+125°C)
∆Cap, DCL, and DF: See standard ratings table
• Step 6 (+25°C)
DCL and DF: See standard ratings table
∆Cap: Within ±5% of step one value
Resistance to Soldering Heat: MIL-STD-202- Method 210, condition C
• DCL and DF: See standard ratings table
• ∆Cap: Within ±5% of initial measurement
Life test at 85°C/125°C, 2000 hours: MIL-STD-202 – Method 108
• DCL and DF: See standard ratings table
• ∆Cap: Within ±10% of initial measurement
Cross Reference
Cornell Dubilier
Type
Series MIL Type Kemet Sprague
Tansitor
Mallory Arcotronics
Typical ESR, C,V
TAT
M39006/22
T192
135D
AQ/HAQ
THT/TLX
TH
Extended Range
TAX
M39006/25
T195
135D
AR/HAR
THT/TLX
TH
These capacitor types are not exactly the same. Review the specifications before purchase to assure interchangeability
Cornell Dubilier • 140 Technology Place • Liberty, SC 29657 • Phone: [phone] • Fax: [phone] • www.cde.com