PBL38620-2 Datasheet, PDF (16/16 Pages) Ericsson – Subscriber Line Interface Circuit

PBL 386 20/2
Power-up Sequence
No special power-up sequence is necessary
except that ground has to be present before
all other power supply voltages.
Printed Circuit Board Layout
Care in PCB layout is essential for proper
function. The components connecting to
the RSN input should be placed in close
proximity to that pin, such that no
interference is injected into the RSN pin.
Ground plane surrounding the RSN pin is
advisable.
Analog ground (AGND) should be
connected to battery ground (BGND) on
the PCB in one point.The capacitors for the
battery should be connected with short
wide leads of the same length.
Ordering Information
Package
24 pin SSOP Tape & Reel
24 pin SOIC Tube
24 pin SOIC Tape & Reel
28 pin PLCC Tube
28 pin PLCC Tape & Reel
Temp. Range
0° - +70° C
0° - +70° C
0° - +70° C
0° - +70° C
0° - +70° C
Part No.
PBL 386 20/2SHT
PBL 386 20/2SOS
PBL 386 20/2SOT
PBL 386 20/2QNS
PBL 386 20/2QNT
Information given in this data sheet is believed to be
accurate and reliable. However no responsibility is
assumed for the consequences of its use nor for any
infringement of patents or other rights of third parties
which may result from its use. No license is granted
by implication or otherwise under any patent or patent
rights of Ericsson Microelectronics AB. These
products are sold only according to Ericsson
Microelectronics AB' general conditions of sale,
unless otherwise confirmed in writing.
Specifications subject to change without
notice.
1522-PBL 386 20/2 Uen Rev. A
© Ericsson Microelectronics AB 1999
This product is an original Ericsson product
protected by US, European and other
patents.
Ericsson Microelectronics AB
SE-164 81 Kista-Stockholm, Sweden
Telephone: [phone]
16