6000-0JD111001 Datasheet, PDF (2/5 Pages) Emcore Corporation – J-Type Medallion 6000 1550 nm Externally Modulated Transmitter

J-Type Medallion 6000 1550 nm
Externally Modulated Transmitter
DATASHEET | JULY 2012
FIBER OPTICS
Optical Characteristics
Property
Units
Models
Comments
Performance (note 1-8)
6000-J01 6000-J02
Specified Link Length
L (km)
25
25
Channel Plan
NTSC 80-Ch PAL 60-Ch
With 36 QPSK carriers from 950 to
2800 MHz
Optical Output Power
Po (dBm)
8.5/8.5
8.5/8.5
Min. 10 dBm version avail. See Chart
Noise Bandwidth
BW (MHz)
4
5
SBS Suppression
(dBm)
15.0
15.0
Min.
CATV Carrier to Noise Ratio
CNR (dB)
51.0
51.0
Min.
CATV Composite Second Order CSO (dBc)
-65
-65
Max. Port 1
CATV Composite Triple Beat
CATV Composite Triple Beat
CTB (dBc)
-65
CTB (dBc)
-64
-65
Max. @ +25C
-64
Max. @ 0^oC to 50^oC
SAT-IF Carrier to Noise Ratio
CNR (dB)
27
27
Min.
SAT-IF Intermodulation Products (dBc)
-35
-35
Max. Port 1
SAT-IF Spurious Products
(dBc)
-38
-38
Max.
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
period.
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2
8. With 36 QPSK modulated SAT-IF signals between 950 … 2800 MHz. 27 MHz IF bandwidth
Test/Link Configuration
Property
J-Type
EDFA
14 dBm
Link
25 Km
Received Power²
0.0 dBm at the receiver
| REV 2012.07
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.