|
GD25Q16C Datasheet, PDF (4/49 Pages) ELM Electronics – 16M-bit Serial Flash | |||
|
◁ |
GD25Q16CxIGx 3.3V Uniform Sector Dual and Quad Serial Flash
1. FEATURES
http://www.elm-tech.com
⦠16M-bit Serial Flash
⦠Program/Erase Speed
- 2048K-byte
- 256 bytes per programmable page
⦠Standard, Dual, Quad SPI
- Standard SPI: SCLK, CS#, SI, SO, WP#, HOLD#
- Dual SPI: SCLK, CS#, IO0, IO1, WP#, HOLD#
- Quad SPI: SCLK, CS#, IO0, IO1, IO2, IO3
⦠High Speed Clock Frequency
- 120MHz for fast read with 30PF load
- Dual I/O Data transfer up to 240Mbits/s
- Quad I/O Data transfer up to 480Mbits/s
- Page Program time: 0.6ms typical
- Sector Erase time: 45ms typical
- Block Erase time: 0.15/0.25s typical
- Chip Erase time: 7s typical
⦠Flexible Architecture
- Sector of 4K-byte
- Block of 32/64K-byte
⦠Low Power Consumption
- 20mA maximum active current
- 5μA maximum power down current
⦠Software/Hardware Write Protection
⦠Advanced Security Features(1)
- Write protect all/portion of memory via software
- Enable/Disable protection with WP# pin
- Top or Bottom, Sector or Block selection
- 64-Bit Unique ID for each device
- 4Ã256-Byte Security Registers With OTP Locks
- Discoverable parameters(SFDP) register
⦠Cycling endurance
⦠Single Power Supply Voltage
- Minimum 100,000 Program/Erase Cycles
- Full voltage range: 2.7~3.6V
⦠Data retention
⦠Package Information
- 20-year data retention typical.
- SOP8 (150mil)
- SOP8 (208mil)
- WSON8 (6Ã5mm)
Note: (1) Please contact ELM for details.
49 - 4
Rev.1.1
|
▷ |