ZABG6002 Datasheet, PDF (9/12 Pages) Diodes Incorporated – LOW POWER 6 STAGE FET LNA AND MIXER BIAS CONTROLLER

A Product Line of
Diodes Incorporated
ZABG6002
General Operation
In both modes the R_CAL 1 and R_CAL 2 pins can also be used as logic inputs. If set to a logic high state (>3.0V), the
associated FET bias stages programmed for LNA use (2V drains) are disabled by driving gate pins to -2,5V and
switching drain pins open-circuit. This feature can be used as part of a power management system that turns off
any unwanted stages in a multi input receiver.
The ZABG6002 includes a switched capacitor DC-DC converter that is used to generate the negative supply
required to bias depletion mode FETs used in common source circuit configuration as shown above. This converter
uses two external capacitors, C_NB the charge transfer capacitor and C_SUB the output reservoir capacitor. The circuit
provides a regulated -2.5V supply both for gate driver use and for external use if required (for extra discrete bias
stages, mixer bias, local oscillator bias etc.). The -2.5V supply is available from the C_SUB pin.
If any bias stages are not required, their gate and drain pins may be left open circuit. If all bias stages associated
with an R_CAL resistor are not required, then this resistor may be omitted.
It must be noted that the exposed pad of the QFN package must be either left floating or connected to Csub.
Ordering Information
Device
ZABG6002JB20TC
ZABG6002Q20TC
Package
QFN2044
QSOP20
Reel size (inches)
13
13
Tape width (mm)
12
16
Quantity per reel
3,000
2,500
Marking Information
QFN2044
QSOP20
Pin 1
Part Name
Date Code
Year/Week
ZABG
6002
YYWW
Part Name
Date Code
Pin 1
ZABG6002
YYWW
ZABG6002
Document number: DS32078 Rev. 1 - 2
9 of 12
www.diodes.com
May 2010
© Diodes Incorporated