English
Language : 

AP7217_10 Datasheet, PDF (8/10 Pages) Diodes Incorporated – 500mA CMOS LDO
AP7217
500mA CMOS LDO
Application Note
Short circuit protection
When VRout pin is shorted to GND or VRout voltage is less than 200mV, short circuit protection will be triggered
and clamp the output current to approximately 50mA.
VDOUT (reset output)
---Open-Drain Active-Low reset output---
In general, VDOUT is pulled up by a resistor (100Kohm) to VIN. The AP7217 microprocess (uP) supervisory
circuitry asserts a guaranteed logic-low reset during power-up and power-down. Reset is asserted asserts when
VIN is below the reset threshold and remain asserted for at least tRP after VIN rises above the reset threshold.
As long as VIN is lower than the reset threshold, VDOUT remains at logic "0". When VIN become higher than VTH, a
logic "1" is asserted after a time delay defined by tRP.
Ordering Information
AP 7217 - 33 S G - 13
Output voltage
33 : 3.3V
Package
S : SOP-8L
Green
G : Green
Packing
13 : Tape & Reel
Device
AP7217-33SG-13
Package
Code
S
Packaging
(Note 3)
SOP-8L
13” Tape and Reel
Quantity
Part Number Suffix
2500/Tape & Reel
-13
Notes: 3. Pad layout as shown on Diodes Inc. suggested pad layout document AP02001, which can be found on our website at
http://www.diodes.com/datasheets/ap02001.pdf.
Marking Information
Logo
Part Number
( Top View )
8
5
7217-33
YY WW X X
1
4
YY : Year : 08, 09,10~
WW : Week : 01~52; 52
represents 52 and 53 week
X : Internal Code
G : Green
AP7217
Document number: DS31292 Rev. 4 - 2
8 of 10
www.diodes.com
April 2010
© Diodes Incorporated