AP91352 Datasheet, PDF (5/12 Pages) Diodes Incorporated – SAS DISABLE plus 5V eFUSE WITH INTEGRATED ISOFET

AP91352
Electrical Characteristics (Cont.) (Note 6) (All specifications are for -10°C < TA < +85°C, VCC = 5V, unless otherwise noted.)
Symbol
Parameters
Conditions
Min Typ Max Unit
SAS Disable
SASL
SASH
SASHmax
SAS-ΩIN
SAS-TDLY
–
Logic Level Low
Logic Level High
Maximum Pin Voltage
Input Impedance
Deglitch Filter
Human Body JESD22-A114
Output Enabled
Output Disabled
–
To GND
–
–
0.35
–
0.7
V
0.8
1.0
2.1
V
–
–
3.3
V
350 500 1000 kΩ
2
–
–
μs
1
–
–
kV
–
Charged Device JESD22-C101
–
500
–
–
V
Notes:
6. Typical data is measured at TA = +25C, VCC = 5V. The maximum and minimum parameters values over operating temperature range are not tested in
production, they are guaranteed by design, characterization and process control.
7. The slew rate control is held in reset until the input voltage is greater than the UVLO rising threshold and Enable = High. The slew rate control is reset
when input voltage drops below UVLO falling threshold, Enable changes from High to Mid or Low, SA = High or reverse current detection.
8. Reverse current detection will latch off the Isofet switch; In AP91352, this condition can be reset by under voltage lock out, by EN/FAULT and SAS pin,
when VOUT falls below the supply pin voltage (VCC) by 100mV typical at TA = +25C, VCC = 5V.
AP91352
Document number: DS38109 Rev. 1 - 2
5 of 12
www.diodes.com
October 2015
© Diodes Incorporated