AP7341 Datasheet, PDF (3/14 Pages) Diodes Incorporated – 300mA HIGH PSRR LOW NOISE LDO WITH ENABLE

AP7341
Electrical Characteristics (@T_A = +25°C, V_EN = V_OUT +1.0V, C_IN = C_OUT = 1.0µF, I_OUT = 1.0mA, unless otherwise specified.)
Parameter
Input Voltage
Output Voltage Accuracy (Note 11)
Conditions
T_A = -40°C to +85°C
V_IN = (V_OUT-Nom+1.0V) to
5.25V, I_OUT = 1mA to 150mA
T_A = +25°C
T_A = -40°C to +85°C
Min
Typ
Max
Units
1.7
—
5.25
V
-1
—
1
%
-1.5
—
+1.5
Line Regulation (dV_OUT/dV_IN/V_OUT) V_IN = (V_OUT-Nom+1.0V) to 5.25V, I_OUT = 1.0mA
—
0.02
0.1
Load Regulation (dV_OUT/V_OUT)
Quiescent Current (Note 6)
I_STANDBY
Output Current
Fold-back Short Current (Note 7)
PSRR (Note 8)
Output Noise Voltage (Notes 8 & 9)
Dropout Voltage
(Note 5)
Output Voltage Temperature
Coefficient
EN Input Low Voltage
EN Input High Voltage
EN Input Leakage
On Resistance of N-Channel for
Auto-Discharge (Note 10)
V_IN = V_OUT-Nom+1.0V, I_OUT = 1mA to 300mA
I_OUT = 0mA
V_EN = 0V (Disabled)
—
V_OUT short to ground
V_IN = [V_OUT +1V] VDC +0.2Vp-pAC,
V_OUT ≥ 1.8V,
I_OUT = 30mA
f = 1kHz
BW = 10Hz to 100kHz, I_OUT = 30mA
1.1V ≤ V_OUT < 1.5V
1.5V ≤ V_OUT < 1.7V
I_OUT = 150mA
1.7V ≤ V_OUT < 2.0V
2.0V ≤ V_OUT < 2.5V
2.5V ≤ V_OUT < 2.8V
2.8V ≤ V_OUT ≤ 3.3V
V_OUT = 1.8V
I_OUT = 300mA
V_OUT = 2.5V
V_OUT = 3.3V
I_OUT = 30mA, T_A = -40°C to +85°C
—
—
V_EN = 0, V_IN = 5.0V or V_EN = 5.0V, V_IN = 0V
V_IN = 4.0V V_EN = 0V (Disabled)
—
15
30
—
35
50
—
0.01
1.0
300
—
—
—
55
—
—
75
—
—
60
—
—
0.50
0.62
—
0.38
0.47
—
0.34
0.42
—
0.28
0.36
—
0.22
0.30
—
0.21
0.27
—
0.50
0.65
—
0.37
0.48
—
0.30
0.40
—
±30
—
0
—
0.5
1.3
—
5.25
-1.0
—
+1.0
—
30
—
Notes:
5. Dropout voltage is the voltage difference between the input and the output at which the output voltage drops 2% below its nominal value.
6. Quiescent current is defined here is the difference in current between the input and the output.
7. Short circuit current is measured with VOUT pulled to GND.
8. This specification is guaranteed by design.
9. To make sure lowest environment noise minimizes the influence on noise measurement.
10. AP7341 has 2 options for output, Built-in discharge and non-discharge
11. Potential multiple grades based on following output voltage accuracy.
%/V
mV
uA
uA
mA
mA
dB
µVrms
V
ppm/°C
V
V
µA
Ω
AP7341
Document number: DS36523 Rev. 4 - 2
3 of 14
www.diodes.com
July 2014
© Diodes Incorporated