English
Language : 

AP7341 Datasheet, PDF (2/14 Pages) Diodes Incorporated – 300mA HIGH PSRR LOW NOISE LDO WITH ENABLE
AP7341
Pin Descriptions
Pin Number
1
2
3
4
X2-DFN1010-4
VOUT
GND
EN
VIN
—
Thermal Pad
Function
Power Output pin
Ground
Enable pin. This pin should be driven either high or low and must not be floating. Driving this pin
high enables the regulator, while pulling it low puts the regulator into shutdown mode
Power Input pin
In PCB layout, prefer to use large copper area to cover this pad for better thermal dissipation,
then connect this area to GND or leave it open. However do not use it as GND electrode function
alone.
Absolute Maximum Ratings (Note 4) (@TA = +25°C, unless otherwise specified.)
Symbol
Parameter
Ratings
Unit
VIN
Input Voltage
6.0
V
VCE
Input Voltage EN
6.0
V
VOUT
Output Voltage
-0.3 to VIN +0.3
V
IOUT
Output Current
400
mA
PD
Power Dissipation
400
mW
TA
Operating Temperature
-40 to +85
°C
TSTG
Storage Temperature
-55 to +125
°C
Note:
4. a). Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. These are stress ratings only and
functional operation of the device at these conditions is not implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device
reliability.
b). Ratings apply to ambient temperature at 25°C . The JEDEC High-K board design used to derive this data was a 2 inch x 2 inch multilayer board with 1-
ounce internal power and ground planes and 2-ounce copper traces on the top and bottom of the board.
Recommended Operating Conditions (@TA = +25°C, unless otherwise specified.)
Symbol
VIN
IOUT
TA
Parameter
Input Voltage
Output Current
Operating Ambient Temperature
Min
Max
Unit
1.7
5.25
V
0
300
mA
-40
+85
°C
AP7341
Document number: DS36523 Rev. 4 - 2
2 of 14
www.diodes.com
July 2014
© Diodes Incorporated