AP6508 Datasheet, PDF (2/14 Pages) Diodes Incorporated – 500kHz 21V 3A SYNCHRONOUS DC/DC BUCK CONVERTER

AP6508
500kHz 21V 3A SYNCHRONOUS DC/DC BUCK CONVERTER
Pin Descriptions
Pin #
1
2,3,4,5
6
7
8
9
10
11
12, 13
14
Name
IN
SW
BST
EN
FB
PG
SS
V_CC
GND
AGND
Exposed PAD
Description
Supply Voltage. The AP6508 operates from a 4.5V to 21V input rail. C1 is needed to
decouple the input rail. Use wide PCB trace to make the connection.
Switch Output. Use wide PCB trace to make the connection.
Bootstrap. A capacitor connected between SW and BS pins is required to form a floating
supply across the high-side switch driver.
EN=1 to enable the chip. For automatic start-up, connect EN pin to VIN by proper EN resistor
divider as Figure 1 shows.
Feedback. An external resistor divider from the output to GND, tapped to the FB pin, sets the
output voltage. To prevent current limit run away during a short circuit fault condition the
frequency fold-back comparator lowers the oscillator frequency when the FB voltage is below
500mV.
Power Good
External Softstart
BIAS Supply. Decouple with 0.μ1F – 0.22μF cap. And the capacitance should be no more
than 0.22μF
System Ground. This pin is the reference ground for the regulated output voltage. For this
reason care must be taken in its PCB layout. Suggested to be connected to GND with copper
and vias.
Analog Ground
No internal connection. It is recommended to connect exposed pad to GND plane for optimal
thermal performance
Functional Block Diagram
AP6508
Document number: DS33437 Rev. 4 - 2
2 of 14
www.diodes.com
July 2011
© Diodes Incorporated