PMC-24V035W1AX Datasheet, PDF (9/13 Pages) Delta Electronics, Inc. – PMC Panel Mount Power Supply

TECHNICAL DATASHEET
PMC Panel Mount Power Supply
24V 35W 1 Phase / PMC-24V035W1A□
Installation of Mounting Accessories
 Only use M3 screw ≤ 6mm (0.23 inch) through the base mounting holes. This
is to keep a safety distance between the screw and internal components.
 Recommended mounting tightening torque: 4~8Kgf.cm (3.47~6.94 lbf.in).
Safety Instructions
– To ensure sufficient convection cooling, always maintain a safety distance of ≥ 20mm (0.78 inch) from all ventilated surfaces while
the device is in operation.
– The device is not recommended to be placed on surface with low thermal conductivity, such as plastics, for example.
– Note that the enclosure of the device can become very hot depending on the ambient temperature and load of the power supply.
Do not touch the device while it is in operation or immediately after power is turned OFF. Risk of burning!
– Do not touch the terminals while power is being supplied. Risk of electric shock.
– Prevent any foreign metal, particles or conductors from entering the device through the openings during installation. It may cause:
Electric shock; Safety Hazard; Fire; Product failure
– The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or instruction.
– Warning: When connecting the device, secure Earth connection before connecting L and N. When disconnecting the device,
remove L and N connections before removing the Earth connection.
– The device is earthed and must be inaccessible.
9
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (March 2016, Rev. 02)