PMH-24V150WCBX Datasheet, PDF (8/13 Pages) Delta Electronics, Inc. – PMH Panel Mount Power Supply

TECHNICAL DATASHEET
PMH Panel Mount Power Supply
24V 150W 1 Phase / PMH-24V150WCB□
Output Load De-rating VS Input Voltage
 No output power de-rating across the entire
input voltage range
Assembly & Installation
Ⓐ Mounting holes for power supply assembly onto the mounting surface.
The power supply shall be mounted on minimum 2 mounting holes using M3 screw minimum 5mm length.
Ⓑ This surface belongs to customer’s end system or panel where the power supply is mounted.
Ⓒ Connector
Side Mounting (Vertical)
Base Mounting (Vertical)
Side Mounting (Horizontal)
Fig. 2 Mounting Orientation
 Use flexible cable (stranded or solid) with the following sizes:
PMH-24V150WCBA (S)
AWG 20-14
PMH-24V150WCBJ (U)
AWG 20-12
PMH-24V150WCBL (V)
AWG 20-12
 The torque at the Connector shall not exceed 13 Kgf.cm (11.23 lbf.in). The insulation stripping length should not exceed 0.275” or
7 mm.
 Please refer the table below for the recommended mating connector, terminal and AWG wire size of PMH-24V150WCBH (T)
Input (JST)
Output (JST)
Power Supply Header
B3P(6-2.3.5)-VH(LF)(SN)
B4P7-VH(LF)(SN)
Mating Connector
VHR-6N
VHR-7N
Terminal
SVH-21T-P1.1
SVH-21T-P1.1
AWG
22-18
22-18
8
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (June 2017, Rev.03)