H48SA53010 Datasheet, PDF (4/13 Pages) Delta Electronics, Inc. – Industry standard pin out

ELECTRICAL CHARACTERISTICS CURVES
Figure 5: Turn-on transient at zero load current (10 ms/div).
Top Trace: Vout, 10V/div; Bottom Trace: ON/OFF input, 5V/div.
Figure 6: Output voltage response to step-change in load current
(75%-50% of Io, max; di/dt = 2.5A/µs).
Load cap: 300µF, electrolytic capacitor and 100µF ceramic
capacitor. Top Trace: Vout (100mV/div), Bottom Trace: Iout
(5A/div). Scope measurement should be made using a BNC cable
(length shorter than 20 inches). Position the load between 51 mm
to 76 mm (2 inches to 3 inches) from the module.
Figure 7: Output voltage response to step-change in load
current (50%-75% of Io, max; di/dt = 2.5A/µs).
Load cap: 300µF, electrolytic capacitor and 100µF ceramic
capacitor. Top Trace: Vout (100 mV/div), Bottom Trace: Iout
(5A/div). Scope measurement should be made using a BNC
cable (length shorter than 20 inches). Position the load between
51 mm to 76 mm (2 inches to 3 inches) from the module.
Figure 8: Test set-up diagram showing measurement points for
Input Terminal Ripple Current and Input Reflected Ripple Current.
Note: Measured input reflected-ripple current with a simulated
source Inductance (LTEST) of 12 μH. Capacitor Cs offset possible
battery impedance. Measure current as shown below.
DS_H48SA53010_10212014
4