DS87C520 Datasheet, PDF (45/45 Pages) Dallas Semiconductor – EPROM/ROM High-Speed Micro

DS87C520/DS83C520 EPROM/ROM High-Speed Microcontrollers
DATA SHEET REVISION SUMMARY
REVISION
091605
070505
040104
070300
070698
022097
110195
DESCRIPTION
1) In DC Electrical Characteristics table, added separate specification for DS83C520 V_PFW.
2) Changed V_RST max to from 4.25V to 4.275V for DS83C520 value.
3) Added Pb-free/RoHS-compliant part numbers to Ordering Information table.
4) Deleted the “A” from the IPC/JEDEC J-STD-020 specification in the Absolute Maximum Ratings.
5) Removed “Preliminary” status.
6) Soldering temperature parameter now references JEDEC specification.
7) Added note to absolute maximums clarifying voltages referenced to ground.
8) Updated I_CC, I_IDLE, I_STOP, I_SPBG, I_IL, and I_TL to incorporate errata conditions.
9) Added note clarifying DC electrical test conditions.
10) Added note clarifying V_OH3 specification applies to first clock cycle following the transition.
11) Updated AC and MOVX electrical characteristics with final characterization values.
12) Added t_AVLL2 specification and corrected MOVX timing diagrams to show t_AVLL2 instead of t_AVLL.
1) Corrected P0 pinout description for TQFP package.
2) Clarified point at which reset delay begins.
1) Update PMM operating current estimates
2) Added note to clarify I_IL specification.
3) Added note to prevent accidental corruption of Watchdog Timer count while changing counter length.
4) Changed minimum oscillator frequency to 1MHz when using external crystal.
5) Changed RST pulldown resistance from 170kΩ to 200kΩ maximum.
6) Corrected “Data memory write with stretch” diagrams to show falling edge of ALE coincident with
rising edge of C3 clock.
1) Update ALE pin description.
2) Add note pertaining to erasure window.
3) Add note pertaining to internal MOVX SRAM.
4) Change Note 10 from RST = 5.5V to RST = V_CC.
5) Change serial port mode 0 timing diagram label from t_QVXL to t_QVXH.
Preliminary release.
45 of 45
Maxim/Dallas Semiconductor cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim/Dallas Semiconductor product.
No circuit patent licenses are implied. Maxim/Dallas Semiconductor reserves the right to change the circuitry and specifications without notice at any time.
Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600
© 2005 Maxim Integrated Products • Printed USA
The Maxim logo is a registered trademark of Maxim Integrated Products, Inc. The Dallas logo is a registered trademark of Dallas Semiconductor Corporation.