English
Language : 

DS1673 Datasheet, PDF (18/20 Pages) Dallas Semiconductor – Portable System Controller
NOTES:
DS1673
1. All voltages are referenced to ground.
2. Logic 1 voltages are specified at a source current of 0.4 mA at VCC=3.0V, VOH=VCC for capacitive
loads.
3. Logic 0 voltages are specified at a sink current of 1.5 mA at VCC=3.0, VOL=GND for capacitive
loads.
4. ICCA is specified with outputs open, CS set to a logic 1, SCLK=500 kHz, oscillator enabled, and D/A
converter enabled.
5. IADC is specified with CS, VCCO open and I/O, SCLK at logic zero. A/D converter is enabled.
6. ICCS is specified with CS, VCCO open and I/O, SCLK at logic zero. A/D converter is disabled.
7. CS has a 40 kΩ pull-down resistor to ground.
8. Measured at VIH=2.0V or VIL=0.8V and 10 ns maximum rise and fall time.
9. Measured at VOH=2.4V or VOL=0.4V.
10. Load capacitance= 25 pF.
11. ICCO=100 mA, VCC > VCCTP.
12. VCCO switchover from VCC to VBAT occurs when VCC drops below the lower of VCCSW and VBAT.
13. Current from VCC input pin to VCCO output pin.
14. Current from VBAT input pin to VCCO output pin.
15. Timebase is generated by very accurate crystal oscillator. Accuracy of this time period is based on
the crystal that is used. A typical crystal with a specified load capacitance of 6 pF will provide an
accuracy within ±100 ppm over the 0°C to 70°C temperature range.
16. If the EOSC bit in the Control Register is set to a logic 1, tRPU is equal to 250 ms plus the start-up
time of the crystal oscillator.
18 of 20