DS1673 Datasheet, PDF (10/20 Pages) Dallas Semiconductor – Portable System Controller

CU BIT TIMING Figure 6
DS1673
3-WIRE SERIAL INTERFACE
Communication with the DS1673 is accomplished through a simple 3-wire interface consisting of the
Chip Select (CS), Serial Clock (SCLK) and Input/Output (I/O) pins.
All data transfers are initiated by driving the CS input high. The CS input serves two functions. First, CS
turns on the control logic which allows access to the shift register for the address/command sequence.
Second, the CS signal provides a method of terminating either single byte or multiple byte (burst) data
transfer. A clock cycle is a sequence of a rising edge followed by a falling edge. For data input, data
must be valid during the rising edge of the clock and data bits are output on the falling edge of the clock.
If the CS input goes low, all data transfer terminates and the I/O pin goes to a high impedance state.
Address and data bytes are always shifted LSB first into the I/O pin. Any transaction requires the
address/command byte to specify a read or write to a specific register followed by 1 or more bytes of
data. The address byte is always the first byte entered after CS is driven high. The most significant bit
( RD /WR) of this byte determines if a read or write will take place. If this bit is 0, one or more read
cycles will occur. If this bit is 1, one or more write cycles will occur.
Data transfers can occur 1 byte at a time or in multiple byte burst mode. After CS is driven high an
address is written to the DS1673. After the address, 1 or more data bytes can be read or written. For a
single-byte transfer 1 byte is read or written and then CS is driven low. For a multiple-byte transfer,
multiple bytes can be read or written to the DS1673 after the address has been written. Each read or write
cycle causes the register address to automatically increment. Incrementing continues until the device is
disabled. After accessing register 0Eh, the address wraps to 00h.
Data transfer for single-byte transfer and multiple-byte burst transfer is illustrated in Figures 7 and 8.
10 of 20