MB39C811 Datasheet, PDF (34/36 Pages) Cypress Semiconductor – Ultra Low Power Buck PMIC Solar/Vibrations Energy Harvesting

MB39C811
Page
Section
Change Results
17
11. Typical Application Circuits
Wiring correction in “Figure 11-1 Application circuit for photovoltaic energy
harvester”
Deleted the wire connections between DCGND1 pin and the bridge
rectifier, then added the internal GND.
17
11. Typical Application Circuits
Wiring correction in “Figure 11-2 Application circuit for vibration energy
harvester”
Deleted the wire connections between DCGND2 pin and the bridge
rectifier, then added the internal GND.
18
11. Typical Application Circuits
Wiring correction in “Figure 11-3 Voltage doubler rectification circuit for
vibration harvester”
Deleted the wire connections between DCGND1 pin and the bridge
rectifier, then added the internal GND.
Added the “Table 12-1 Manufactures of recommended inductors”
19, 20
12. Application Notes
Added the “Table 12-2 Manufactures of photovoltaic harvesters”
Added the “Table 12-3 Manufactures of vibration harvesters”
Added the “Table 12-4 Manufactures of capacitors”
23 to 28 13. Typical Characteristics
Inserted the data of 22μH and 10μH together into “Figure 13-1 Typical
characteristics of DC/DC conveter”.
Inserted the data of 22μH and 10μH together into “Figure 13-4 Switching
waveforms of DC/DC converter”.
23, 24
13. Typical Characteristics
Replaced the line regulation datas of 22μH in “Figure 13-1 Typical
characteristics of DC/DC conveter”
Replaced the load regulation datas of 22μH in “Figure 13-1”
Added the line and load regulation data of 10μH in “Figure 13-1”.
31
16. Ordering Information
Deleted “Table 16-2 EVB Ordering information”
NOTE: Please see “Document History” about later revised information.
Document Number: 002-08401 Rev *A
Page 34 of 36