CY7C67200_06 Datasheet, PDF (24/78 Pages) Cypress Semiconductor – EZ-OTG™ Programmable USB On-The-Go

CY7C67200
Host n Count Result Register [R]
• Host 1 Count Result Register 0xC088
• Host 2 Count Result Register 0xC0A8
Figure 23. Host n Count Result Register
Bit #
15
14
13
12
11
10
9
8
Field
Result...
Read/Write
R
R
R
R
R
R
R
R
Default
0
0
0
0
0
0
0
0
Bit #
7
6
5
4
3
2
1
0
Field
...Result
Read/Write
R
R
R
R
R
R
R
R
Default
0
0
0
0
0
0
0
0
Register Description
The Host n Count Result register is a read-only register that
contains the size difference in bytes between the Host Count
Value specified in the Host n Count register and the last packet
received. If an overflow or underflow condition occurs, that is
the received packet length differs from the value specified in
the Host n Count register, the Length Exception Flag bit in the
Host n Endpoint Status register will be set. The value in this
register is only valid when the Length Exception Flag bit is set
and the Error Flag bit is not set; both bits are in the Host n
Endpoint Status register.
Result (Bits [15:0])
The Result field contains the differences in bytes between the
received packet and the value specified in the Host n Count
register. If an overflow condition occurs, Result [15:10] is set
to ‘111111’, a 2’s complement value indicating the additional
byte count of the received packet. If an underflow condition
occurs, Result [15:0] indicates the excess byte count (number
of bytes not used).
Reserved
All reserved bits must be written as ‘0’.
Host n Device Address Register [W]
• Host 1 Device Address Register 0xC088
• Host 2 Device Address Register 0xC0A8
Figure 24. Host n Device Address Register
Bit #
15
14
13
12
11
10
9
8
Field
Reserved...
Read/Write
-
-
-
-
-
-
-
-
Default
0
0
0
0
0
0
0
0
Bit #
7
6
5
4
3
2
1
0
Field
...Reserved
Address
Read/Write
-
W
W
W
W
W
W
W
Default
0
0
0
0
0
0
0
0
Register Description
The Host n Device Address register is a write-only register that
contains the USB Device Address that the host wishes to
communicate with.
Address (Bits [6:0])
The Address field contains the value of the USB address for
the next device that the host is going to communicate with.
This value must be written by firmware.
Reserved
All reserved bits must be written as ‘0’.
Document #: 38-08014 Rev. *G
Page 24 of 78
[+] Feedback