MB3793-34A Datasheet, PDF (21/26 Pages) Cypress Semiconductor – Precise detection of power voltage fall: 2.5%

MB3793-34A
12. Usage Precaution
1. Do not configure the IC over the maximum ratings
If the lC is used over the maximum ratings, the LSl may be permanently damaged.
It is preferable for the device to normally operate within the recommended usage conditions. Usage outside of these conditions
can have a bad effect on the reliability of the LSI.
2. Use the devices within recommended operating conditions
The recommended operating conditions are under which the LSl is guaranteed to operate.
The electrical ratings are guaranteed when the device is used within the recommended operating conditions and under the condi-
tions stated for each item.
3. Printed circuit board ground lines should be set up with consideration for common impedance
4. Take appropriate measures against static electricity
• Containers for semiconductor materials should have anti-static protection or be made of conductive material.
• After mounting, printed circuit boards should be stored and shipped in conductive bags or containers.
• Work platforms, tools, and instruments should be properly grounded.
• Working personnel should be grounded with resistance of 250 k to 1 M between body and ground.
5. Do not apply negative voltages
The use of negative voltages below –0.3 V may create parasitic transistors on LSI lines, which can cause malfunctions.
13. Ordering Information
Part number
MB3793-34APNF
Package
8-pin plastic SOP
(FPT-8P-M02)
Remarks
Document Number: 002-08556 Rev. *A
Page 21 of 26