CY7C187_06 Datasheet, PDF (2/9 Pages) Cypress Semiconductor – 64K x 1 Static RAM

CY7C187
Maximum Ratings
(Above which the useful life may be impaired. For user guide-
lines, not tested.)
Storage Temperature ................................. –65°C to +150°C
Ambient Temperature with
Power Applied............................................. –55°C to +125°C
Supply Voltage to Ground Potential
(Pin 22 to Pin 11) ........................................... –0.5V to +7.0V
DC Voltage Applied to Outputs
in High Z State^[1] ............................................ –0.5V to +7.0V
DC Input Voltage^[1] .........................................–0.5V to +7.0V
Output Current into Outputs (LOW)............................. 20 mA
Static Discharge Voltage............................................ >2001V
(per MIL–STD–883, Method 3015)
Latch-Up Current ..................................................... >200 mA
Operating Range
Range
Commercial
Ambient
Temperature
0°C to +70°C
V_CC
5V ± 10%
Electrical Characteristics Over the Operating Range
Parameter
V_OH
V_OL
V_IH
V_IL
I_IX
I_OZ
I_CC
I_SB1
I_SB2
Description
Output HIGH Voltage
Output LOW Voltage
Input HIGH Voltage
Input LOW Voltage^[1]
Input Leakage Current
Output Leakage
Current
V_CC Operating
Supply Current
Automatic CE Power-
Down Current^[3]
Automatic CE
Power-Down Current
Test Conditions
V_CC = Min., I_OH = –4.0mA
V_CC = Min., I_OL=12.0 mA
GND < V_I < V_CC
GND < V_O < V_CC,
Output Disabled
V_CC = Max.,
I_OUT = 0 mA
Max. V_CC, CE ≥ V_IH
Max. V_CC, CE ≥ V_CC – 0.3V,
V_IN ≥ V_CC – 0.3V
or V_IN ≤ 0.3V
-15
-25 and -35
Min. Max. Min. Max. Unit
2.4
2.4
V
0.4
0.4
V
2.2
V_CC
2.2
V_CC
V
–0.5 0.8
–0.5
0.8
V
–5
+5
–5
+5
µA
–5
+5
–5
+5
µA
90
70
mA
40
20
mA
20
20
mA
Capacitance^[4]
Parameter
C_IN
C_OUT
Description
Input Capacitance
Output Capacitance
Test Conditions
T_A = 25°C, f = 1 MHz,
V_CC = 5.0V
Max.
Unit
10
pF
10
pF
AC Test Loads and Waveforms
5V
OUTPUT
R1 329 Ω
30 pF
R2 202 Ω
INCLUDING
JIG AND
SCOPE _(a)
5V
OUTPUT
R1 329 Ω
5 pF
R2 202 Ω
INCLUDING
JIG AND
SCOPE _(b)
C187–4
3.0V
10%
GND
≤ 5 ns
ALL INPUT PULSES
90%
90%
10%
≤ 5 ns
C187–5
Equivalent to: THÉVENIN EQUIVALENT
125Ω
OUTPUT
1.90V
Notes:
1. V_IL (min.) = –3.0V for pulse durations less than 30 ns.
2. Not more than 1 output should be shorted at one time. Duration of the short circuit should not exceed 30 seconds.
3. A pull-up resistor to V_CC on the CE input is required to keep the device deselected during V_CC power-up, otherwise I_SB will exceed values given.
4. Tested initially and after any design or process changes that may affect these parameters.
Document #: 38-05044 Rev. *A
Page 2 of 9
[+] Feedback