CY2CC910 Datasheet, PDF (2/8 Pages) Cypress Semiconductor – 1:10 Clock Fanout Buffer

Maximum Ratings^[1]
Storage Temperature: .................................–65°C to +150°C
Ambient Temperature:................................... –40°C to +85°C
Supply Voltage to Ground Potential
V_CC .................................................................. –0.5V to 4.6V
Input ................................................................. –0.5V to 5.8V
Variable Output Impedance Control (VOI™)
COMLINK™ SERIES
CY2CC910
Supply Voltage to Ground Potential
(Outputs only) ........................................... –0.5V to V_DD + 1V
DC Output Voltage.................................... –0.5V to V_DD + 1V
Power Dissipation........................................................ 0.75W
Pull Down
3.5
3
2.5
2
1.5
1
0.5
0
0
0.01
0.02
0.03
0.04
0.05
0.06
0.07
0.08
0.09
0.1
Iol (A)
Vdd = 3.3 V
Vdd = 2.5 V
Vdd = 1.8 V
Pull Up
3.5
3
2.5
2
1.5
1
0.5
0
-0.18
-0.16
-0.14
-0.12
-0.1
-0.08
-0.06
-0.04
-0.02
0
Ioh (A)
Vdd= 3.3 V
Vdd= 2.5 V
Vdd= 1.8 V
Figure 1. Output Voltage vs. Output Current ( TA = 25°C)
DC Electrical Characteristics @ 3.3V (see Figure 2)
Parameter
V_OH
V_OL
V_IH
Description
Output High Voltage
Output Low Voltage
Input High Voltage
V_IL
I_IH
I_IL
I_I
V_IK
I_OK
O_OFF
V_H
Input Low Voltage
Input High Current
Input Low Current
Input High Current
Clamp Diode Voltage
Continuous Clamp Current
Power-down Disable
Input Hysteresis
Conditions
V_DD = Min., V_IN = V_IH or V_IL
V_DD = Min., V_IN = V_IH or V_IL
Guaranteed Logic High
Level
I_OH = –12 mA
I_OL = 12 mA
Guaranteed Logic Low Level
V_DD = Max.
V_IN = 2.7V
V_DD = Max.
V_IN = 0.5V
V_DD = Max., V_IN = V_DD(Max.)
V_DD = Min., I_IN = –18 mA
V_DD = Max., V_OUT = GND
V_DD = GND, V_OUT = < 4.5V
Min.
2.3
2
Typ.
3.3
0.2
–0.7
80
Max.
0.5
5.8
0.8
1
–1
20
–1.2
–50
100
Unit
V
V
V
V
uA
uA
uA
V
mA
uA
mV
Note:
1. Stresses greater than those listed under absolute maximum ratings may cause permanent damage to the device. This is intended to be a stress rating only and
functional operation of the device at these or any other conditions above those indicated in the operation sections of this specification is not implied. Exposure
to absolute maximum rating conditions for extended periods may affect reliability.
Document #: 38-07348 Rev. *A
Page 2 of 8