CY8CLED04_10 Datasheet, PDF (1/37 Pages) Cypress Semiconductor – EZ-Color™ HB LED Controller

CY8CLED04
EZ-Color™ HB LED Controller
Features
■ HB LED Controller
❐ Configurable Dimmers Support up to four
Independent LED Channels
❐ 8 to 32 Bits of Resolution per Channel
❐ Dynamic Reconfiguration Enables LED Controller Plus Other
Features: CapSense, Battery Charging, and Motor Control
■ Visual Embedded Design
❐ LED-Based Drivers
• Binning Compensation
• Temperature Feedback
• Optical Feedback
• DMX512
■ PrISM Modulation Technology
❐ Reduces Radiated EMI
❐ Reduces Low Frequency Blinking
■ Advanced Peripherals (PSoC^® Blocks)
❐ Four Digital PSoC Blocks Provide:
• 8 to 32-Bit Timers, Counters, and PWMs
• Full-duplex UART
• Multiple SPI Masters or Slaves
• Connectable to all GPI/O pins
❐ Six Rail-to-Rail Analog Psoc Blocks Provide:
• Up to 14-Bit ADCs
• Up to 9-Bit DACs
• Programmable Gain Amplifiers
• Programmable Filters And Comparators
❐ Complex Peripherals By Combining Blocks
❐ Capacitive Sensing Application Capability
■ Complete Development Tools
❐ Free Development Software
• PSoC Designer™
❐ Full Featured, In-Circuit Emulator and Programmer
❐ Full Speed Emulation
❐ Complex Breakpoint Structure
❐ 128 KBytes Trace Memory
■ Programmable Pin Configurations
❐ 25 mA Sink, 10 mA Source on all GPI/O
❐ Pull Up, Pull Down, High Z, Strong, or Open Drain Drive
Modes on all GPI/O
❐ Up to 12 Analog Inputs on GPI/O
❐ Four 30 mA Analog Outputs on GPI/O
❐ Configurable Interrupt on all GPI/O
■ Flexible On-Chip Memory
❐ 16K Flash Program Storage 50,000 Erase/Write Cycles
❐ 1K SRAM Data Storage
❐ In-System Serial Programming (ISSP)
❐ Partial Flash Updates
❐ Flexible Protection Modes
❐ EEPROM Emulation in Flash
■ Full Speed USB (12 Mbps)
❐ Four Uni-Directional Endpoints
❐ One Bi-Directional Control Endpoint
❐ USB 2.0 Compliant
❐ Dedicated 256 Byte Buffer
❐ No External Crystal Required
Cypress Semiconductor Corporation • 198 Champion Court
Document Number: 001-13108 Rev. *C
• San Jose, CA 95134-1709 • 408-943-2600
Revised January 15, 2010
[+] Feedback