DS-72-35 Datasheet, PDF (12/14 Pages) Cymbet Corporation – EnerChip™ RTC Evaluation Kit

Preliminary
CBC-EVAL-12-34123 EnerChip RTC Evaluation Kit
From this window, click on the ‘Get Registers’ box to reveal the bit settings. An example of the register map is
shown in the following window.
To adjust the registers, click on either the ‘Bit Set’ or ‘Bit Reset’ box in the lower left corner of the register map,
window then click on the field in one of the ‘Bit’ columns to set or reset, respectively, that register bit. When
finished setting the register fields, click the ‘Set Register’ button in the lower right corner of the window.
When finished using the CBC-EVAL-12-34123, click the ‘RTC EC Power’ button in the main GUI window to turn
off power to the module. Then click on the ‘Disconnect’ button and remove the USB dongle from the computer.
©2013 Cymbet Corporation • Tel: [phone] • www.cymbet.com
DS-72-35 V0.7

Page 12 of 14