450T220R103B1A1 Datasheet, PDF (2/9 Pages) CTS Corporation – Industrial 15/16 inch (24mm) Diameter 1/2 Watt Composition Variable Resistors

Electrical and Mechanical Specifications (continued)
Locating Lugs (Bushing Mounted Style)
Standard Position : Left side with terminals facing inward
Available : No lug, right lug or two lugs with terminals
facing inward
Shaft Information
Metal Shafts : Aluminum standard
Length : Standard — Up to 3" in 1/8" increments.
Special — Consult CTS
Diameter : Standard — .250" (6.35mm)
Special — Consult CTS
Molded Shafts —
Length : Standard — Round, Flatted & knurled shafts
available up to 11/2" (38.1mm) in
1/8" (3.2mm) increments
Special — Some molded shaft designs
available up to 2" (50.8mm). Consult CTS
Diameter : Diameter over knurl —
.240" – .246" (6.10mm – 6.25mm)
Color : Colors are available.
Vernier Constructions
This construction is designed for fine tuning
applications. It provides precision adjustments
in 3700° (10¹/4 turns) or 2000° (5 ¹/2 turns)
Long Life Construction
This construction provides an extended life of 250,000
cycles (with a limited rotation angle) and is available
with resistance ranging from 10K ohms to 5 megohms,
linear taper only. Consult CTS for other tapers.
Metal Tubing Shafts —
Length : Standard — Up to 3" (76.2mm)
Special — Consult CTS
Outside Diameter :
Rear Extended Shafts — 265" (6.73mm) or .250"(6.35mm)
Metal or molded rear extended shafts available.
Typical Constructions
The following is basic information on the most
common CTS 15/16" (24mm) diameter composition
variable resistor constructions supplied to our
customers. Space limitations prohibit showing the
virtually thousands of additional constructions fabri-
cated to exacting customer specifications. For your
special applications the CTS engineering staff is
at your disposal for designing the best and most
economical construction to meet your requirements.
2-9
CTS Electronic Components
© 2007 CTS Corporation. All rights reserved. Information subject to change.
01/25/07
www.ctscorp.com