|
450T220R103B1A1 Datasheet, PDF (1/9 Pages) CTS Corporation – Industrial 15/16 inch (24mm) Diameter 1/2 Watt Composition Variable Resistors | |||
|
Series 450
®
Industrial 15/16"
(24mm) Diameter
1/2 Watt Composition
Variable Resistors
Features
⢠Low cost
⢠Versatile mounting styles:
â bushing
â twist tab
â bend tab
â snap-in PC bracket
â solder lug or PC terminals
⢠Wide resistance range
⢠Molded / metal shaft & bushing
⢠Pull-push, Push-push and rotary power switches
⢠Shaft and bushing waterseal available
⢠Rear extended shaft available
⢠Single, tandem, or concentric constructions
⢠Special vernier adjust (multiturn) construction
available for fine adjustment
⢠Long life construction available
Electrical and Mechanical Specifications
Resistance Range
100 ohms through 10 megohms (linear taper)
Long life construction - 10K ohms through 5 megohms
(linear taper)
Resistance Tolerance
Standard: ±20%
Special: ±10%
Power Rating, Watts
1/2 watt 10K ohms, 1/3 watt; above 10K ohms through
100K ohms, 1/4watt above 100K ohms. Full rating @
55°C, derated to no load at 85°C
Resistance Tapers
Standard â Linear,10% Audio and 10% CCW Audio
Special â Consult CTS
Rotational Angle
Standard Construction
Total Rotation: with rotary switch â 320° ± 5°
Total Rotation: without switch or with push-pull
or push-push switches â 300° ± 5°
Vernier Adjust Construction
Shaft Rotational Angle
VA-450 â 3700° â 10 1/4 turns
5VA-450 â 2000° â 5 1/2 turns
Voltage Rating
Bushing to Terminals:
High pot test, one minute
Standard construction â 1080VAC
Vernier construction â 1000VAC
Operating maximum â 750VDC
Across End Terminals:
500 VDC, load not to exceed listed wattage ratings.
Special: 1500/1800VAC high pot available.
Effective Rotation
With or without switch â 300° (approximate)
Special angle available â consult CTS
Bushing Information
Diameter: EIA Standard 3/8"-32 UNEF-2A thread.
Standard length: 3/8 " or 1/4 " (9.53mm or 6.35mm)
Special length available upon request
Metric bushing available upon request
RoHS Compliant
All models of 450 series pot. are now RoHS compliant
except 040 and 041 push-push power switches. The
two models of power switches are RoHS compliant
available upon request.
(continued on next page)
1-9
CTS Electronic Components
© 2007 CTS Corporation. All rights reserved. Information subject to change.
01/25/07
www.ctscorp.com
|
▷ |