DC100D10C Datasheet, PDF (3/8 Pages) Crydom Inc., – Power Plus DC Series

Datas^Pah^nele^Me^out^nt
MECHANICAL SPECIFICATIONS ⁽²⁾
Tolerances: ±0.02 in / 0.5 mm
All dimensions are in: inches [millimeters]
Screw Termination
1.1
[27.9]
0.49
[12.4]
Mounting
Hole/Slot
0.19 [4.9]
DIA.
1.88
[47.6]
1
OUTPUT
+2
SOLID STATE RELAY
4
INPUT
+3
1.7
[43.2]
0.89
[22.6]
2.25
[57.3]
Hex Standoff Termination (“K” Option) (1)
1.1
[27.9]
0.49
[12.4]
Mounting
Hole/Slot
0.19 [4.9]
DIA.
1.04
[26.4]
(2 places)
1.88
[47.6]
1
OUTPUT
+2
SOLID STATE RELAY
4
INPUT
+3
1.7
[43.2]
2.25
[57.3]
1.0
[25.4]
1.75
[44.5]
Screw Termination, IP20
1.1
[27.9]
0.49
[12.4]
Mounting
Hole/Slot
0.19 [4.9]
DIA.
1.0
[25.4]
1.75
[44.5]
0.93
[23.6]
(4 places)
1.0
[25.4]
(2 places)
1.88 1.7
[47.6] [43.2]
2.32
[58.8]
2.25
[57.3]
1.0
[25.4]
1.75
[44.5]
1.22
[30.9]
GENERAL NOTES
(1) Option “K” is designed and tested for use with printed circuit boards or ring/fork terminals having a thickness between 0.031 and 0.093 inches (0.79 to 2.36 mm), and loads rated up to 50 Amps.
For higher load currents, the “K” standoff temperature must not exceed 105°C. For additional application assistance please contact Crydom Technical Support.
(2) All parameters at Tc=25°C unless otherwise specified.
(3) Heat sinking required, see derating curves.
(4) Low current loads and high ambient temperature can affect turn-on time.
(5) 8VDC minimum control voltage. Resistive loads only. Consider switching losses; at maximum frequency reduce to 75% output current.
(6) Increase minimum voltage by 1V for operations from -20 to -40°C.
(7) Decrease maximum control voltage 1.35V/°C above 80°C ambient temperature.
(8) All parameters at 50% power rating and 100% duty cycle (contact Crydom tech support for detailed report).
For additional information or specific questions, contact Crydom Technical Support.
Do not forget to visit us at: www.crydom.com
Copyright © 2016 Crydom Inc. Specifications subject to change without notice.