PT62SCMD12 Datasheet, PDF (10/12 Pages) Cree, Inc – Dual 1200V SIC MOSFET driver

4.4. Modifying dead-time and OCP settings
In this section information is given for modifying dead time, VDS trip level and/or blanking time.
Modifying dead-time
The dead time can be programmed by assembling the resistors R901 and R902 (0603 package).
Values of the resistors should be 220Ohm or lower. The possible settings are listed below.
Figure 4-2, Location R901 and R902
Datasheet PT62SCMD12 SIC MOSFET driver R08
© 2014 Prodrive Technologies B.V.
15 September 2014
10 of 12