FMSA-461 Datasheet, PDF (5/6 Pages) Interpoint Corporation Company – EMI INPUT FILTER 28 VOLT INPUT

EMI INPUT FILTERS
Dot on top of case
indicates pin one.
CASE A
BOTTOM VIEW _{0.805 max}
See cases A1 - A3 _(20.45)
for pin configurations.
0.980 max
(24.89)
Materials
Header Kovar/Nickel/Gold
(Case A3, Kovar/Nickel)
Cover Kovar/Nickel
Pins
Kovar/Nickel/Gold,
matched glass seal
Case dimensions in inches (mm)
Tolerance ±0.005 (0.13) for three decimal places
±0.01 (0.3) for two decimal places
unless otherwise specified
CAUTION
Heat from reflow or wave soldering may damage
the device. Solder pins individually with heat
application not exceeding 300 C for 10 seconds
per pin.
FIGURE 7: CASE A MAXIMUM DIMENSIONS
FMSA EMI FILTER
0.8 AMP
BOTTOM VIEW CASE A1
FMSA EMI Filter and STF EMI Filter
Seam Seal Projection Weld
0.697
(17.70
0.397
(10.08)
0.097
(2.46)
0.000
Squared corner and dot on
top of case indicate pin one.
1
23
8
4
7
65
0.018 ± 0.002 dia.
(0.46 ± 0.05)
Seal hole: 0.056 ±0.002 (1.42 ±0.05)
FIGURE 8: CASE A1
Please refer to the above written numerical dimensions for accuracy.
®
5