TL602-024M Datasheet, PDF (3/3 Pages) Connor-Winfield Corporation – TCXO Specification Models TL602 and TVL602

2111 Comprehensive Drive
Aurora, Illinois 60505
Phone: [phone]
Fax: [phone]
www.conwin.com
Design Recommendations
Vcc, should have
a large copper
area for reduced
inductance.
Connect a 0.01uF
bypass capacitor
<0.1”(2.54mm)
8
from the pad. ₉
6
5
0.010”(0.254mm)
Recommended
clearance
inductance
for internal
copper flood.
Vcc
10
1
3
Top View
4
Ground,
should have
a large copper
area for reduced
inductance.
Ground
Top View
OSC
TOP LAYER
GROUND LAYER
50 Ohm Trace
Without _Output
Vias _Buffer
50 Ohm trace
<1”by design
Buffer
Ground
BOTTOM LAYER
Attention: To achieve optimal frequency stability, and in some cases to meet the specification stated on this data sheet, it is required that the circuit
connected to this TCXO output must have the equivalent input capacitance that is specified by the nominal load capacitance. Deviations from the
nominal load capacitance will have a graduated effect on the stability of approximately 20 ppb per pF load difference.
Tape and Reel Dimensions
PIN 1
8.46 DIA
(216mm DIA)
.69
(17.5mm)
.08
(2.0mm)
9.84 DIA
(250mm DIA)
.08
(2.0mm)
3.15
(80mm)
1.00 DIA
(25mm DIA)
MEETS EIA-481A and EIAJ-1009B
2,000 PCS/REEL
16mm Tape
.31
.08 ^(7.9mm)
(2.0mm)
.21
(5.4mm)
.315
(8.0mm)
.157
(4.0mm)
.06 DIA
(1.5mm DIA)
.295 (7.5mm)
.07 (1.75mm)
.83 (16.0mm)
TV602 Test Circuit
Enable/
Disable DNC DNC
Vcc
Supply
Voltage
0.1 uF
Bypass
10 nF
Bypass
8 76
9
5
10
1
23
Ground
4
N/C
DNC DNC DNC
DNC = D o Not Connect
Output
15 pF
TVL602 Test Circuit
Vcc
Supply
Voltage
0.1 uF
10 nF ⁴
3
Bypass
Bypass
1
2
Pad 1 N/C
Output
15 pF
Specifications subject to change without notification. See Connor-Winfield's website for latest revision. All dimensions in inches.
© Copyright 2015 The Connor-Winfield Corporation Not intended for life support applications.
Bulletin
Page
Revision
Date
Tx414
3 of 3
02
19 March 2015