CY14B101Q1_10 Datasheet, PDF (10/24 Pages) Cypress Semiconductor – 1 Mbit (128K x 8) Serial SPI nvSRAM

CY14B101Q1
CY14B101Q2
CY14B101Q3
Figure 8. Write Status Register (WRSR) Instruction Timing
CS
SCK
SI
SO
01 23 4 5 6 701 2 3 4 5 6 7
Opcode
Data in
0 0 0 0 0 0 0 1 D7 0 0 0 D3 ^D2 0 0
MSB
LSB
HI-Z
Write Protection and Block Protection
CY14B101Q1/CY14B101Q2/CY14B101Q3 provides features
for both software and hardware write protection using WRDI
instruction and WP. Additionally, this device also provides block
protection mechanism through BP0 and BP1 pins of the Status
Register.
The write enable and disable status of the device is indicated by
WEN bit of the status register. The write instructions (WRSR and
WRITE) and nvSRAM special instruction (STORE, RECALL,
ASENB, and ASDISB) need the write to be enabled (WEN bit =
1) before they can be issued.
Write Enable (WREN) Instruction
On power up, the device is always in the write disable state. The
following WRITE, WRSR, or nvSRAM special instruction must
therefore be preceded by a Write Enable instruction. If the device
is not write enabled (WEN = ‘0’), it ignores the write instructions
and returns to the standby state when CS is brought HIGH. A
new CS falling edge is required to re-initiate serial communi-
cation. The instruction is issued following the falling edge of CS.
When this instruction is used, the WEN bit of status register is
set to ‘1’. WEN bit defaults to ‘0’ on power up.
Note After completion of a write instruction (WRSR or WRITE)
or nvSRAM special instruction (STORE, RECALL, ASENB, and
ASDISB) instruction, WEN bit is cleared to ‘0’. This is done to
provide protection from any inadvertent writes. Therefore,
WREN instruction needs to be used before a new write
instruction is issued.
Figure 9. WREN Instruction
CS
SCK
01 234567
SI
00000110
SO
Hi-Z
Write Disable (WRDI) Instruction
Write Disable instruction disables the write by clearing the WEN
bit to ‘0’ in order to protect the device against inadvertent writes.
This instruction is issued following falling edge of CS followed by
opcode for WRDI instruction. The WEN bit is cleared on the
rising edge of CS following a WRDI instruction.
Figure 10. WRDI Instruction
CS
SCK
01 234567
SI
00000100
SO
Hi-Z
Block Protection
Block protection is provided using the BP0 and BP1 pins of the
Status register. These bits can be set using WRSR instruction
and probed using the RDSR instruction. The nvSRAM is divided
into four array segments. One-quarter, one-half, or all of the
memory segments can be protected. Any data within the
protected segment is read only. Table 6 shows the function of
Block Protect bits.
Table 6. Block Write Protect Bits
Level
0
1 (1/4)
2 (1/2)
3 (All)
Status Register
Bits
BP1 BP0
0
0
0
1
1
0
1
1
Array Addresses Protected
None
0x18000-0x1FFFF
0x10000-0x1FFFF
0x00000-0x1FFFF
Document #: 001-50091 Rev. *D
Page 10 of 24